12 hours ago, HumptyDumpty said:

return rgb / (rgb + 0.5) * 3.0;

Are you sure you've reverted this change too? The original didn't have 0.5 there.

7 minutes ago, RXP said:

Are you sure you've reverted this change too? The original didn't have 0.5 there.

Hi,

I put the original stuff  from you.  so it 2.2 now

Edited May 29, 20188 yr by HumptyDumpty

Ok I think I've found why it might be 'too' bright (too vibrant). The default argument I've left in the code is:
rgb = PostProcessVibrancy(rgb, 1.1);

But it should be:
rgb = PostProcessVibrancy(rgb, 0.1);

when using 0, it won't change anything.
when using 0.1 it boosts vibrancy by 10%.

Using the "TonemapSubtle" example fits perfect for me 😄

Thanks so much, Marcel

I'm preparing an updated file with simpler to select params.

Sounds good. now using 0.1 it looks better just need more brightness.

On 5/29/2018 at 8:58 PM, Cellinsky said:

Using the "TonemapSubtle" example fits perfect for me 😄

Thanks so much, Marcel

mind sharing how you implimented it?

Thank you Jean-Luc. I have one problem though, I am getting Dome.gsli error on start up.

Edit: Sorted...syntax error.

Edited June 1, 20188 yr by ZKOKQ

2 hours ago, ZKOKQ said:

Thank you Jean-Luc. I have one problem though, I am getting Dome.gsli error on start up.

Edit: Sorted...syntax error.

I was getting the same error and didnt read that that line should be below that code 

#endif   this might be the issue. 

 

1 hour ago, HumptyDumpty said:

I was getting the same error and didnt read that that line should be below that code 

#endif   this might be the issue. 

 

Will try again tomorrow. Thought I had sorted it. Thanks for that.