3 hours to download 1.95gig!, at this rate I should have it fully downloaded in time for it's 1st service pack.

Finally!!!!

Well I’m happy to say my download did finish around 10:30am local this morning and the last six hours has seen me complete the install, configure my controls (sort of) and competed a couple of short flights in the X-Cub.

Very pleased with my progress so far and the performance on my old rig. I do get warnings that my rig is below the minimum specs and may not run correctly, even though the do match slightly higher than the published minimum specs.

My focus is trying to map my Saitek X55 stick and throttles. I noticed in a folder (called inputs) that only the x56 is offered.

I have slowly progress to a point now that I have the joystick controlling Ailerons and Elevators, pause, parking brakes, Auto pilot on/off.

The Throttles are now working for two engines, Flaps, Elevator trims, Landing Gear, Reverse thrust.

What I have not been able to do is map any views to the stick or throttles especially the POV hat. If anyone has a clue about these I may help me losing any more hair.

Cheers Anton.

 

p.s. Forgot to mention that there was a configuration file for my Saitek Pro Rudder pedals and they worked Straight out of the box (Rudder and toe brakes)

Edited August 18, 20205 yr by antonvs

5.5 hour total here  here.  It seemed to have stopped somewhere in the middle of the night. 

Downloaded in about 4 hours in Central USA. 

Edited August 18, 20205 yr by Alcides Segovia