v4 All A/C pull sharp to right on taxi takeoff

[oldngray 8]

Recently using Carenado C210 in Landing config 82 kts, the A/C dove and turned sharp to right. Unable to recover. Later using the AC11 the same thing happened.

Now cold and dark start C210, D-18, F22 and AC 11  when brakes released and power applied the A/C turns sharp to right.  Difficult to control with full left controls.

[ark 1,288]

I would check calibration of the right brake if you are using brake pedals.

Al

Edited August 30, 2020 by ark

[oldngray 8]

Nope, not Brake Pedals, but thanks for the thought.

[ARCO 245]

After a Windows update recently, I had a similar problem, all my axis and key assignments had changed and I had a lot of a mess to sort out, all my planes were turning left regardless of my actions and re-calibration. I decided to assign all my axis and keys to FSUIPC, and de-activate the hardware controller in P3D, problem solved now.

[oldngray 8]

Going to reload v4 to see if that corrects it.

[oldngray 8]

Reload oof v4 no help.

Going to try the FSUIPC6 route.

[tfm 169]

I also had this issue with my x52 pro.

 

In my case the solution was simple: unplug the controller. Plug it in again.

[oldngray 8]

Did not realize how many issues there were with the CH Yoke and P3D v4.5. Also not sure when this started.  The issues included complete loss of directional control and Yoke Button assignments changed without my input. I did not have the problems with FSX, only v4 P3D.

Purchased and installed FSUIPC v6 and all of the problems I had with control are gone.

Have to get the paid version but that is well worth it.

Happy once again,

 

[oldngray 8]

Spoke too soon, Today both Carenado airplanes are basically unflyable. 😬 Default A/C and FSX are not affected.😅

Somehow Axis and Button assignments are being changed without my input, on takeoff have turning to right, unable to correct without using left brake.

Also had complete Nav failure. All Navaids just went dark. Methinks will wait until either Saitek or Honeycomb have products available for purchase.

I have had this Yoke since MSFS 4.

[787flyer 633]

I once had this problem and I traced it down to competing joystick and yoke plugged in at the same time. I unplugged all my devcies, started the sim and plugged in the device I was intending to use.