Good day. I am experiencing difficuly configuring my Saitek Throttle with MSFS. It only gives me the option of "Throttle 1" in the controller settings. Therefore only one of the throttles responds to inputs. Is there a way to get both throttles to respond equally to one lever input? Regards.

Look for just "Throttle Axis" in the control settings under "Power Management."

22 minutes ago, leefree said:

Look for just "Throttle Axis" in the control settings under "Power Management."

Have you had any lock setting up the TQ for the TBM? I can't figure out how to set it up so I can put it in all of the positions.

Nice Avatar, BTW. Looks like at least one thing is normal in today's world - the Lions still suck.

3 minutes ago, duckbilled said:

Have you had any lock setting up the TQ for the TBM? I can't figure out how to set it up so I can put it in all of the positions.

Nice Avatar, BTW. Looks like at least one thing is normal in today's world - the Lions still suck.

hahaha thanks.

I haven't used the TBM yet. I've been flying the King Air and C172 steam gauge and G1000 versions.

On 9/27/2020 at 5:14 PM, leefree said:

Look for just "Throttle Axis" in the control settings under "Power Management."

Sorry for the late reply. Thanks. Found it...I was using "Throttle 1".

On 9/27/2020 at 9:39 AM, duckbilled said:

Have you had any lock setting up the TQ for the TBM? I can't figure out how to set it up so I can put it in all of the positions.

I'm in the exact same boat. The TBM's strange throttle settings (or not, really) are hard to map to a HOTAS. The only advice I can give, is the prop lever (like you'd use for a C172) helps switch the throttle from the lo/hi to the taxi throttle settings. So you can switch it back and forth with that. I still haven't figured out how to switch it to the CUT OFF setting.