I installed vox atc into p3dv4.5.  I was able to get it to work with all of my addon aircraft, except for the fs labs airbus.  It shows up in that plane, but then cases p3d to ctd.  I had to manually modify the panel.cfg to even get it to show up, but have no ide why it is ctd.  As soon as I remove the panel.cfg modification, it no.longer crashes to desktop.  Any ideas?

2 hours ago, Greg Goodavish said:

I had to manually modify the panel.cfg to even get it to show up,

greg

& then, you had a CTD ?

2 hours ago, Greg Goodavish said:

As soon as I remove the panel.cfg modification

it works ??

a tad confused......though i have heard elsewhere that you can't tweak FSL's *.cfg's.

I don't know what variants of the FSL Bus you have but when you use the panel config tool, only tick the box of the first one in each variant. I have multiple liveries for each variant (A319 CFM, A319 IAE, A320 CFM, A320 IAE....) Each of those liveries has its own box. If you check all of them it will mess up your install. If that's not it then you may have to install the Vox panel for each variant separately.

 

What I meant was the VOX Atc gauge shows up when I manually added the entries in the panel.cfg file, but then it almost immediately caused a CTD.  As soon as I removed those edits from the panel.cfg file, of course the gauge was removed, but the plane worked again with no CTD.

19 hours ago, Greg Goodavish said:

What I meant was the VOX Atc gauge shows up when I manually added the entries in the panel.cfg file, but then it almost immediately caused a CTD.  As soon as I removed those edits from the panel.cfg file, of course the gauge was removed, but the plane worked again with no CTD.

Does it matter where you add the VOXATC lines in panel.cfg? If you didn't add them as the last of the gauge entries, try that.

Has anyone successfully added it to the panel.cfg with no CTD?  If so, can you share how you did it?