Here's the link - bare i mind it is beta..

 

CTD every time try to enter VR mode... switching back

Scrub that,... works well...turns out id forgotten to disable HDR.... dumb eh! LOL

Does it fix the issue where your headset display shuts off and you have to lift up the headset from your eyes for a few seconds or go out then back into VR for the display to turn back on. This started happening about 6-8 weeks ago on my Crystal OG, but the issue may be related to NVIDIA drivers or the Beta and not the Play software. 

It happened to me too when I tried 1.39 a couple of weeks ago. I haven't tried the new one because I'm a bit wary now. I'll wait until they fix it before I try again.

But incidentally, there's a power button on the top right of the CL which is easy to reach while you're simming. There are two buttons, the long one is a rocker switch for adjusting the volume, but the one in front turns it on or off. Just hit that button to turn it on again when it goes off.

6 hours ago, Gulf76 said:

Does it fix the issue where your headset display shuts off and you have to lift up the headset from your eyes for a few seconds or go out then back into VR for the display to turn back on.

Must admit, haven't had that issue before... when selecting the room area, you now have to do a full 360 pan around to set it... then its done... i also changed the light in my room to a much brighter one..things going well so far...

On 5/11/2025 at 1:15 PM, Gulf76 said:

Does it fix the issue where your headset display shuts off and you have to lift up the headset from your eyes for a few seconds or go out then back into VR for the display to turn back on. This started happening about 6-8 weeks ago on my Crystal OG, but the issue may be related to NVIDIA drivers or the Beta and not the Play software. 

Wondering this as well...😐  I've since put the headset down because of the issues I've been seeing.