Has anyone had issues with MSFS2024 crashing the moment before your plane touches down? I've had this happen a bunch of times and mostly with the Black Square Bonanza.

Thanks!

Mike Caparula

This used to be an issue from time to time in 20, though not for a long time. There are so many potential causes of CTD on landing, it's pretty hard to nail down. Does it happen mostly at busy airports with a lot of traffic and scenery detail?

7 hours ago, Nandengo12 said:

This used to be an issue from time to time in 20, though not for a long time. There are so many potential causes of CTD on landing, it's pretty hard to nail down. Does it happen mostly at busy airports with a lot of traffic and scenery detail?

No, actually. It happens with GA flying at smaller airports. Most recently at KHGR, a small regional airport, which also means using stock sceneries as well.

1 hour ago, cappy42 said:

No, actually. It happens with GA flying at smaller airports. Most recently at KHGR, a small regional airport, which also means using stock sceneries as well.

That's a head scratcher. You probably need to catch it in the Event Viewer next time it happens, just to even have an idea of where to start looking

3 hours ago, cappy42 said:

No, actually. It happens with GA flying at smaller airports. Most recently at KHGR, a small regional airport, which also means using stock sceneries as well.

Disable all addons, and I mean Marketplace add-ons too....except I guess I'd keep the BS Bonanza loaded since it's the plane where you've had this problem. Then try to reproduce.

Sometimes people disable Community folder add-ons but forget to disable Marketplace add-ons.

Fwiw, I had almost this same problem last year when flying the Fenix. Every single time I would land, CTD. I spent lots of time with Fenix trying to figure out the problem, but to no avail. Every other plane I tested worked fine. Then, I finally figured out that I had updated my video card drivers before the CTD's with the Fenix started. By this time, there was even a newer stable driver available, so I updated to that one, and voila...no more CTD's with the Fenix (or anything else). I don't know why that particular driver version did not like the Fenix, but for whatever reason that was the problem. I had spent weeks trying everything else to check off potential causes. Nothing else worked. Only the driver update fixed it.

Your issue may be similar or may not be, but just wanted to post this information so maybe it could help.