matthieu

Sorry perhaps my confusion trying to understand the primary, secondary, pilot, first officer commands.After more reading and trial it seems no error as reported.The message in the primary window is asking to raise the gear, the message in the secondary window is giving me the option to abort.Matt

I load FSX with the default plane then switch to PMDG 737, before takeoff.I go thru the flow till I get to Takeoff, during the takeoff roll I get Gear Up on the main side and Abort on the secondary window? I have tried to reload the flight several times but get the same message.Any help for a newbie would be appreciated.Matt

from cold and dark, I do the following, battery switch to onstandby switch to on move IRS from off to nav I get ON DC indicated above the IRS selectors, It goes out on the left selector but stays illuminated on the right selector. After a short period I then get an alarm tone, I did not get this prior to HF4. Any ideas? Matt

load the 737-800 from the 'Free Flight' menu once loaded, open the CDU, menu, PMDG SETUP, PANEL STATE LOAD, select NGX CLDDRKclick EXEC at OVEHEAD BAT to ONSTANDBY PWR to AUTO START APU (left click twice) when APU GEN illuminate, set both to ON APU BLEED to ONENG 1/2 BLEED to ON L/R PACK to OFFISOL to OPEN R ENG START to GRN at THROTTLE at N2 = 25%R FUEL lever to IDLE at OVERHEAD ENG GEN 2 to ON repeat for ENG 1 good luck, Matt

Win7 64bitFSX SP2NGX with HotFix 3Intel Core 2 CPU 6700 @ 2.66GHz, air cooled2 GB ramNvidia GeForce 7950 GX2, 1GB mem (512MB per GPU) On board soundWD 500GB dedicated to FSXWD 80GB dedicated to Win 7 Matt

I just tired your flight twice, 1st using CMD1, 2nd using CMD2. Both using VNAV and LNAV. I didn't get any lockups or freezes as you mentioned Matt Intel Core 2 CPU 6700 @ 2.66GHz, 2.0GB ram, Nvidia GeForce 7950 GX2, Win 7 64bit SP1, FSX SP2, NGX hotfix 3

the site www.smartcockpit.com has some very detailed info and pics of the various sections of the overhead panel. look under, my aircraft, boeing, 737 ng matt

Jack, I have tried it using the updated magdec.bgl file, and also using the stock magdec.bgl file and get the same thing? Just tried CYYZ runway 05 and all worked fine, very nice landing. Matt

thank you for the reply, I am using the default stock FXS scenery. Matt

I was trying to do a few touch and goes at CYYZ runway 23 and noticed on final appr that the ILS is not aligned correctly? I have the ILS for 23 set as 111.50 and the CRS set as 237 but land about 5ft left of the runway? I have updated the magvar as per the thread in the General Forum. Is this a known prob with FSX and runway 23? thanks, Matt Henry