Search the Community

Hello, Gentlemen! I like the original 737-s in reality, IMHO it is one of the great birds of the late 1960-es, along with DC-9, Tu-154, Il-62, 747 and others. I always wanted to fly it in FS, and one day, I realized, that there is such a good, highly detailed model of this plane. So, I have installed the Tinmouse II 737, and I loved this model. But I have some problems with it. It would be really nice, to solve them and fly the plane with only pleasant remarks. First of all, the stabilizer trim is VERY fast. I think my passngers are flying up and down around the cabin with their seatbelts still fastened Really, a single, hardly-felt 0.1-second click already shifts the trim a few units. I just keep trying to fly as soft and carefully, as I can, and still imagine myself in these possible g-loads. Also there is an issue with the CWS. (I think it is one of the direct consequences of the trimming problem) It is too agressive. I have to stop the rotation at the point, where I want it to stop, applying sufficient counter-pressure to the yoke, if I just release it the plane will continue to rotate rapidly for a few more seconds. One time, I was lucky (I have no idea of how did I get this) to have the normal-speed trim, just for a traffic pattern, and then a short trial flight to another local airport. I was surprised about how smooth can this aircraft really be, both in CWS and with hands. Is there any way to keep it this slow, exept the registered FSUIPC settings? I am using a wide panel, introduced in version 1.40, and many lamps and lights there are misplaced. I've seen a topic with the corrected locations for the speedbrake and marker lights, but they are placed completely incorrectly, while there are many other lights (I can say most of them, on the front panel), that are shifted slightly over their bitmaps, making the text hardly readable. Are there any corrected panel config sections? I am not good at all in panel building, so I would not like the idea to find and fix them myself, if there are any ready solutions availible. The red gear lights are illuminated all the time, while the gear are up. It is not normal, is that? What can I do with this? I don't want to go to the old 4:3 panel :( P.S Are the incompleted points of the 1.32 wish-list still topical? Are there any plans for a new visual model in some version, or some fixes to the current one, if its source materials are still avalible? It would be nice, for example, to have an ability to open the doors and hatches on the starboard side, and control the aft door independently from the stairs, and the flat flight-attendants near the exits sometimes look annoying, also it would be nice to have an ability to remove them. P.P.S Sorry, I can't upload the file here (don't know why, it just fails), I am talkng about this photo: http://commons.wikimedia.org/wiki/File:Boeing_737-2V6_Advanced_Cockpit_Dubai_Air_Show_Ryabtsev.jpg?uselang=ru Who knows, what is the CDU in the top-left corner of the pedestal for? Is it an INS? Or some other type of long-range navigation? And what is located to the left of it, on the captain's panel? Thank You for your assistance, everyone! Sorry for my English, Best regards

Hello folks, Hoping someone can help me out with (what should be) a simple question, but I cannot figure it out for the life of me! Just recently ventured into the land of repainting for the MD-11 for a VA I joined, all has gone well so far, expect for one thing... I am trying to paint the horizontal stabilizer surfaces to match the body, but I cannot for the life of me figure out where (in which file and layer name) they are located within the paint kit...I was able to paint the wings to match, but cannot for the life of me me find the horizontal stabilizer. Thanks in advance to anyone who can help me out! -Mike Demers