Search the Community
Showing results for tags 'v1.6'.
Found 3 results
-
Hi, I know this is an old topic and I've searched everywhere for a solution but haven't found one yet so I thought I'd ask anyway in the hope that someone out there that reads this has worked one out. The auto brakes on my Aerosoft Airbus X A320 and A321 disconnect every time I land. I've tried low and medium and tried bringing the throttles to idle at a variety of hieghts i.e. 20', 30'. 40' and 50' just before landing but the deacceleration green light pops on for a second then both lights go out and I have to brake manually. I've also tried using reverse thrust and not using reverse thrust. I can't believe there isn't a solution to this very insignificant but annoying little problem. Any help from anybody would be sincerely appreciated. Regards Steve
-
Hi Bryan, Can you explain the flow for getting the ASU disconnected via voice control? Perhaps I am doing something wrong. I am using the Voice control for the T7 and currently running v1.6 for FSX (boxed). When I start from the T7 Cold and Start panel state I run through the Preflight and the various checklists to the point where pushback is requested. At that point I disconnect the A/C unit then start the right engine using the connected ASU and GPU. Right engine spools up with no problem. Then once I have the left engine spooling up, I disconnect the GPU try via voice (successful) and then disconnect the ASU. The voice command I use is recognized to disconnect the ASU and I get a reply from the Ground Crew a few seconds later stating this has been done however when looking at the open F/Os FMC and Ground Connection status I do not see the status change in the ASU transitioning from connected to disconnected. If I request via voice again to disconnect the ASU a 2nd time, I see a small "flicker" of state on the F/O FMC but the state of the ASU remains connected, but the reply from the Ground Crew this time around is that it is already disconnected. The only way to resolve this situation is by clicking the ASU disconnect option in the FMC to disconnect manually. Everything else is working fine. What am I missing? Thanks Mark Just realized I posted this in the PMDG. Not the FS2Crew forum. Kyle or another Moderator can you please move this to the right forum ? Many thx and sorry about that! Mark
-
Hello Boys, Have you noticed that sometimes you just can not steer the front wheel after landing? I Think this starts before landing. I Notice that the 3 red lights from the Landing gear, remain in red even after the gears are down..... the manual talk about an unsafe condition, but..... i know im not above the speed for extention(Or may be there is something im not conscious of), the matter is that, everytime that happens, after landing i can not steer the front wheel and i dont have lights.... Some pictures: 1- The Unsafe 3 red lights remain ON during normal landing procedure(In the final approach). In this picture i just landed, and the green lights are activated because i was hitting the test button, but i culd not turn that off no matter what i did. 2- If i got this behavior before landing, then i have no lights after landing. Dont know if they are related: 3- But after pressing the repair button, i recover all the control back, even the steering... That is happening randomly i think... Will perform another flight and check if that continues. Thanks in advance for support,
