Search the Community
Showing results for tags 'brakes'.
Found 3 results
This is an odd one. Have been trying to solve this for about 3 hours. No matter which B747 variant I attempt to load, when I disconnect all ground services/vehicles and set the wheel chocks to "REMOVED", a "CHCKS INHBT message appears under all the service vehicle lines in the CDU. I read Kyle's response to another user that mentioned if you load P3D with a PMDG 747 as default or switch between variants in a session, this can happen... but that isn't the case here. Here's the scenario: 1. Load P3D with default F-22 2. Load any B747 at any airport with the "747 Short" panel state 3. Verify there are no ground services or vehicles connected. 4. Verify visually that the chocks are set in-place on the landing gear. 5. Select "Wheel Chocks" to "REMOVED" on the CDU 6. CHCKS INHBT message appears in CDU under all service vehicles. What I've done: 1. Searched all the provided PMDG 747 PDFs - found nothing on this issue 2. Searched the internet for comments on "CHCKS INHBT" - nothing found 3. Removed the modified Prepar3D.cfg and allowed P3D to recreate - problem persists 4. Loaded a B747F model - same issue occurrs 5. Disabled ChasePlane (problem stared after I loaded it) - problem persists Any ideas? What file is used by all QOTS B747 variants that could be causing this? Thanks in advance for your help or suggested troubleshooting steps!
Hello, I have brakes, both left and right set to joystick trigger button (Logitech X-52 Professional) and it works, but there is about a second worth of delay before brakes take effect and braking action starts. This also happens visually. When I press the brakes, the pedals in VC twitch a bit and then gradually go down. This makes speed control rather difficult and unpredictable. Is anyone else experiencing this or know of a solution?
Hello, When I Land in the PMDG 737NGX I activate the reversers (which take ages to come out) and then at 70 kts i turn off the reversers and use the toe brakes but they dont work and i over run the runway! Can Anyone Please Help Me? Kind Regards David