When i do take off and manually apply thrust the plane starts but i keeps beepingI did:set flap 5Ab on rtoTrimSet fmc rte and perf and tak offWhat am i missing

When i do take off and manually apply thrust the plane starts but i keeps beeping I did:set flap 5Ab on rtoTrimSet fmc rte and perf and tak off What am i missing

What about the spoilers and the Auto-throttle arm button switch? Is there any warning message when you reset the warning message panel?

No need for spoilers, and no need to arm the auto-throttle. Make sure that when you put your take off data in the FMC, that you are using that flap setting you have input into the FMC :)

AFAIK the only things that will set off the takeoff config horn are:FlapsTrimParking brakeChocks (this will set off the takeoff config alarm in the NGX).

AFAIK the only things that will set off the takeoff config horn are:FlapsTrimParking brakeChocks (this will set off the takeoff config alarm in the NGX).

And T/O speed settings on the FMC?

And T/O speed settings on the FMC?

Not sure about the real thing but just booted up mine (any excuse not to go to bed!) from cold and dark to test the warning horn and didn't even touch the IRS/CDU. The horn went away as soon as I had configured the flaps, trim, parking brake, and chocks (since PMDG basically made the chocks a parking brake anyway).

Here are the things that will set it off in the real plane Trailing edge flaps are not in the the flaps 1 through 25 takeoff range, orLeading edge devices not configured for takeoff, orSpoilers not down with the speedbrake lever in the down position, orParking brake is set, orStabilizer trim not set in the takeoff range. There are no FMC inputs that will cause a takeoff warning.

You know I want to say it.But I will be flamed.I hope you find the answer to your problem though.

When I arm my spoilers for take off i get the take off warning? When i put them down it stops.So in the 737 you don`t arm the spoilers for a RTO.

You do not arm the spoilers for takeoff. If the spoiler handle is not in the down position it will cause a takeoff configuration warning. See my post above. That is directly from the operating manual. The spoilers will deploy when to following conditions occur: Main Landing gear wheels spin up (more than 60 kts)Both throttles are retarded to IDLEReverse thrust levers are positioned for reverse thrust.

in an unrelated note. Is it possible to have a zone temp light turn on when it's broken? I accidentally tried to start the engines with the packs on. Could that break something?

No it shouldn't break anything. All you should see is the engines spool up much more slowly and not achieve normal max motoring RPM if the pack are on. There would be no effect on the ZONE TEMPS.