After testing with the fix applied, I can now access saved situations, but they no longer load the FMC info. Must use the saved panel file and the saved route file (if you made one). Good news is that it no longer banks uncontrollably after AP disconnect but my computer locks up entirely (must reboot to get out of FSX) when I manually begin the flare before touchdown. I have submitted a separate trouble ticket on this. Anyone else with this issue?

+1 was enter a manual speed restriction in LEGS page, locked it up and no controls. Joe

After upgrading new driver for Nvidia 9500 GT and doing complete clean re-install of ORIGINAL NGX, I am having no CTD or freezes. Sometimes, however, when I try to access the weather menu or save flight menu I get complete texture corruption when I attempt to return to flight. I am sure this is being caused by my driver update since I have noticed some issues (though not nearly as prominent) when using my other complex add-ons. Obviously, since NGX is so texture intensive (and cfg is now set @ 4096 for this aircraft) I would expect that any texture problems would certainly be more prevalent. Bottom line: I am going to stay with these new drivers for now since I am having no problems completing flights without incident provided I do not attempt to access other menu screens during takeoffs or landings. What a fabulous simulation!!!

This bug stilllll afflicting me..plane turns to right bank above 20-30 radio alt on approach with LAND 3 autoland..

This sudden roll bug is STILL NOT FIXED after hotfix 4.

http://www.youtube.com/watch?v=0TCoHtgiiEU&feature=player_detailpage

*clean installation of RTM, then applied HotFix #4*While CAT III autoland, suddenly A/P disconnected and heavily banked right.Totally uncontrollable with joystick and struggled to maintain runway heading with rudder.This is a replay video - actual bank is more deeper than replay.

I too just had a complete barrel roll happen about 100-50AGL on final into EGLL 27R. Have just installed the latest HF following all the instructions

I had a simular problem with the maddog in FS9 back in 2009 when disengaging AP se this http://www.simulator...g+indstillinger and this http://www.simulator..._Title=I+luften I found out that it was a controller issue for me with the Saitek Yoke or a double keyboard combination command /Michael