Anyone figured out how to get the Flightline N or T gauges into the C337? Carenado went and changed the panel.cfg format. I added them to the V35 and C-208 but stumped on this one. I can probably live without the gauges but I'd really like to get my GF-166 radio units to work. Typically these units work great without any programming with just about any aircraft payware or not but they're not working either? Appreciate any help in advance.

As mentioned in the topic above - the RXP T and N gauges are not possible with this plane,since all gauges are part of the 3d model. Don't know about your radios..

I tried swapping the GMA340 audio panel and the GTX327 transponder as well as the Friendly Panels 165 com2/nav2 radio. No joy. Seems Carenado has changed the modeling on the 337 panel. This is the first Carenado plane I've owned that I can not change out the avionics using FSPS.Bert, I respect your opinions here, Have you tried an avionics swap?

That's too bad looks like I'll go back to the Duke and V35 for my GA flying then. I was however able to get my GF166's working, though. I have also been able to get most of the controls including the AP mapped through FSUPIC so it's not a total wash.

Hello Blaze,I personally own 8 Goflight devices, My MCP (not PRO!) and my GF166 works great besides of my other Goflight modules with the C337! I can control NAV/COM1/2 , ADF and Transponder in conjunction with a RP48 module. No special assignments were needed, just working as allways.But I have to say that I am using the RXP GNS530 as COM1 / NAV1 device and cannot tell if it is the Carenado Garmin 530 (Nav1/Com1) that causes the problem ?!My current Goflight software isn´t the newest 2.03 it is still 1.95.4 ("never touch a running sytem") , maybe there is a problem too ?! Adding other gauges to a 3D gauges panel isn´t possible, I only managed to exchange my RXP GTX327 and GMA 340 till the C210 release as they were allready fitted with Carenado versions. Hope I could help just a bit! Best regards,Andreas EDDN