Jump to content

Archived

This topic is now archived and is closed to further replies.

samdean

EzDoc problem with SP1?

Recommended Posts

With SP1, is anyone else experiencing an EzDoc problem - in the sense that when switching to an Aircraft view, you don't really leave the VC? This causes you to see the big "PMDG" box behind the cockpit, and the engines etc. aren't visible.Thank you,Sam Khareu

Share this post


Link to post
Share on other sites

Maybe try running the EZDOK configurator again?The aircraft.cfg files will have been replaced when installing the SP1 and the eyepoints will need to be readded by EZDOK

Share this post


Link to post
Share on other sites
Maybe try running the EZDOK configurator again?The aircraft.cfg files will have been replaced when installing the SP1 and the eyepoints will need to be readded by EZDOK
Thank you. Problem solved.

Share this post


Link to post
Share on other sites
Maybe try running the EZDOK configurator again?The aircraft.cfg files will have been replaced when installing the SP1 and the eyepoints will need to be readded by EZDOK
Thanks Graham! I'd forgotten about EZDOK's configurator too.- Maury Pratt

Share this post


Link to post
Share on other sites
Maybe try running the EZDOK configurator again?The aircraft.cfg files will have been replaced when installing the SP1 and the eyepoints will need to be readded by EZDOK
Hello.I have almost same problem. When I leave cockpit view to Aircraft views I see the airplane fallen apart. I ran config tool and no luck. Can you give me a bit more details how can I re-add eye-points? NOt sure I understood how you guys fixed it. Thank you.

Share this post


Link to post
Share on other sites
Maybe try running the EZDOK configurator again?The aircraft.cfg files will have been replaced when installing the SP1 and the eyepoints will need to be readded by EZDOK
Until now when i read the posts here, i had forotten all about Ezdok, yet i had completely uninstalled NGX (via the control panel) and then redownloaded a new installer inlcusive of SP1, reinstalled NGX and went flying. I did not run EzDok configurator or reinstall my camera files or my effects files, yet everything works exactly as before.How come? Well maybe the answer is that when i initially set up EzDok with my NGX , i created a Ezdok folder in each of my four PMDG 737 folders and put my profile files in there. So i guess when i uninstalled, those 737 folders must have been left because of some non PMDG content.

Share this post


Link to post
Share on other sites

×
×
  • Create New...