Bryan,I am getting only one switch or control to respond to my commands. The green bar shows all commands correctly as does the log. The only switch that will respond is the taxi light and it will only go from off to on. It will not turn off. I am starting FSX with the ultralight and then after it is loaded I switch to the PMDG 737-800 WG. I have tried MCP settings and overhead panel.Any thoughts would be appreciated.Thanks,Tom Hibben

Bryan,I am getting only one switch or control to respond to my commands. The green bar shows all commands correctly as does the log. The only switch that will respond is the taxi light and it will only go from off to on. It will not turn off. I am starting FSX with the ultralight and then after it is loaded I switch to the PMDG 737-800 WG. I have tried MCP settings and overhead panel.Any thoughts would be appreciated.Thanks,Tom Hibben

Hi Tom,Have a look here, this may helphttp://forum.avsim.net/topic/365650-hot-fix-1-coming-all-read/

Hi Tom,If you see the command in the Green Bar, that's good.However, if the commands aren't doing anything, it means probably you're not in the right mode.Follow the FS2Crew "Flows"s to the letter.Also, a lot of commands require you to be in the air for them to work... remember, as the Pilot Flying and Pilot Taxiing, you are responsible for the MCP on the ground as per real world procedure.Also, Damien is writing a tutorial which we'll release in a few days... it'll help clear things for the new people.Cheers,

Yep, making sure your are in the right mode on the Main panel is KEY. Otherwise, you can not Call for Before Taxi Checklist if you main panel is saying "Before Takeoff" or "S.Crew/Eng Start" . . . it is an easy mistake to make.