I just noticed I have no Airliner Traffic in any major airports. I see GA Traffic flying around.

 

Not sure what happened.

 

When I start FSX, I hear the big boom sound of Ultimate Traffic II being loaded.

 

I tried sh!ft-F12. No luck

 

Anyone knows whats going on?

 

Manny

You check the UT2 UI to make sure its still checked on?

You check the UT2 UI to make sure its still checked on?

 

Yeah,, my traffic is set to 100%

 

Manny

The FSX CFG file might have gotten changed, be sure to see if it still has the traffic in the AI section.

 

 

Yeah,, my traffic is set to 100%

 

Manny

 

What I meant is do you have the box checked where it says "Display Traffic" in the Weekly Traffic Density area. If the slider is 100% but that box is not checked then no airliners.

 

Otherwise check to make sure a/c casts shadows on ground is turned off since thats not supported at some after market airports and makes traffic not show.

What I meant is do you have the box checked where it says "Display Traffic" in the Weekly Traffic Density area. If the slider is 100% but that box is not checked then no airliners.

 

Otherwise check to make sure a/c casts shadows on ground is turned off since thats not supported at some after market airports and makes traffic not show.

 

Yes..it is checked.. But here is the weird part

 

I go to KSEA (Seattle) and I see Airline traffic. I can increase and decrease UT Traffic. Every functionaly of UT II to inject and reset traffic works when I am in KSEA. But when I move to KDFW, KLAX, EDDF, etc...no traffic. I used to have traffic in all those places.

 

It works in EHAM too. No problem there.

I was beginning to suspect that at FSDT addon airports I am not not getting any traffic.

 

I think I am going MAd

 

I didn't have traffic in Fly Tampa's Boston either/.... But I just went there again.. and now there is traffic.

 

I now have traffic all over the place except at FSDT Airports

 

Hmm...

 

Forget it guys..it now working.. even in DFW. I never did anything. It just started working.

 

I hate it when this happens..

 

:)

All right my AI Problem has returned. And I think I know the culprit. Its the ENB thingi.. After I took them out..slowly I got the AI back and then when I put them back My AI Airliners have disappeared.

 

I suspected its the Sh!ft+F12 key conflicting with the UT II's Sh!ft+ctrl+F12 to inject more AI. But then I reassigned the keys for UT II.

 

Anyone else using UT II and ENB having this issue?

 

Manny

yes..having this issue

No airliner ground traffic.

But a lot of general aviation trafficin the air.

Anyone found a solution?

Whats ENB?

Check your fsx.cfg file, be sure the entry to the UT2 aircraft folder is in the Main section.

 

Example

SimObjectPaths.6=SimObjects\UT2 Aircraft

Thanks, I found the issue. For some reason I had duplicate entries of simobjects in cfg file. All working nice now.