Manual Flight Problem

[matho95 0]

Hey, first i want to say sorry for my English.

 

My Problem is, that always when i am flying the MD11, the Horn is going forward and backward. It is like the MD11 would have a fly by wire. It is very hard to land the MD11 manual, because the elevator is lagging, for e.g. if you make a minimal movement at joystick the elevator is going to the maximum and stays there until go move against it. If i am pressing "Z" and stay on it, then i can fly the MD11 perfeclty. But i a stop pushing it the problem comes back. Do you have any ideas ? I hace a Saitek Cyborg X and reinstallation dind't solved the problem.

 

Best regards

 

Matthias

[3-2-1-Now 126]

Hi,

 

Check the configuration of the LSAS, and ensure the trim is set correctly for takeoff. If yu remain within the roll brackets (ckeck the top of the ADI on the PFD) the LSAS will auto-trim to the last pitch when the stick is centered. If your stick is noisy then this function may not operate correctly.

 

You can change the LSAS sensitivity in PMDG -> Options. I have it set to HARD.

 

Best regards,

Robin.

[PHXMD-11 86]

the Horn is going forward and backward.

 

Is your controller calibrated correctly? Perhaps it's spiking.

[matho95 0]

Hi,

 

Check the configuration of the LSAS, and ensure the trim is set correctly for takeoff. If yu remain within the roll brackets (ckeck the top of the ADI on the PFD) the LSAS will auto-trim to the last pitch when the stick is centered. If your stick is noisy then this function may not operate correctly.

 

You can change the LSAS sensitivity in PMDG -> Options. I have it set to HARD.

 

Best regards,

Robin.

 

I've tested a lot, and it doesn't change anything. I think the reason is my joystick, because when you want to correct a minimum you can't do this with my joystick. Tested an older joystick, the probllem is the same but only for extremly joystick movement