Hello.

 

I'm having a bit of a problem with the voice version of FS2crew.

The flow procedures and checklists work perfectly but when the Start Crew/Engine start comes on and I try to contact the ground crew via "Cockpit to ground" phrase, no response is given.

 

Things i have done are:

 

FLT switches ON:

 

Service Interphone is OFF:

 

I have also tried with the SVT switches ON and Service Interphone ON and still nothing happens. The program does recognise the phrase correctly, as I trained it to do so and the green back shows "Captain: Cockpit to ground" message.

 

I'm completely lost, so any help will be much appreciated.

 

Jorge S.

 

Hi Jorge,

 

Are you getting the SDK warning message?

The correct switch positions as per the manual are I believe:

 

Service Interphone on the aft overhead - ON

Mic Selector on central pedestal - SVC ON and volume up

 

These work for me!

 

You have the mic set to FLT not SVC

Thanks for the replies.

 

Bryan, I did get an SDK error but it disappeared after reloading the aircraft. 

 

ailchim, I did try with teh service interphone on, and the selector on SVC yet nothing happened

 

I'm  almost 100% sure I am setting the radios right.

Double check the manual to ensure you're doing everything right:

 

http://www.support.fs2crew.com/help/manuals/#pageid=pushback___start_crew_dialogues

 

Assuming you don't get the SDK warning message and your audio panel is setup, you should definitely hear the ground crew assuming you're using the correct phrases.

I'm 100% sure I did set up everything as per the manual. I just don't know what may be going wrong. I double-checked everything loads of times and spoke the correct phrase, but nothing happens.

Which airport are you trying at?

 

Try at a different airport... try it at KSEA.