I just installed a new EVGA 970 GTX and have seen a nice improvement with FSX and Steam.

 

Question is P3d SLI compatible? If so, would adding a 2nd 970 card and installing P3D make P3D better than FSE on my system.

 

Thanks

 

Randy

Yes it is SLI compatible. Since I think P3D out of the box is better than FSX:SE it can only get better with SLI. Whether YOU think it's better is up to you.

 

 

Vic

I run two EVGA 970 GTX SSC in SLI and it runs good in P3Dv2.5 & v3

I run two EVGA 970 GTX SSC in SLI and it runs good in P3Dv2.5 & v3

 

Same here with the above hardware  - Better Graphics is possible and AA maintaining FPS . But FPS is not increased. (v3.0)

 

You should know that it is not possible to undock panels and for instance move them to a second or third monitor in SLI

 

Otherwise its really nice. using it all the time in the Dash8 and all my GA flights

 

Michael Moe

Just a small heads up regarding SLI.

 

I desided to take an image of my current setup and then installed the 3.1 Client and content update and so far i am really happy with the results.

 

For some reason , it seems better in SLI than with 3.0.

 

I am still running 1920x1200 and now that we have dynamic reflections its possible to see 80-90% on both of my GTX970´s and still have smooth flight experience. (KRDD Redding maxed out with FTX NCA , 8X AA etc, terrain shadows, ULTRA water) (Real Air Duke Turbine v2 -25-35fps)

 

Need to test this further . I am not sure this settings is saved with your personal saved graphic settings btw.

 

I find it hard to see these reflection at night in the NGX for instance so no need to push the system at those late hours.

 

There is only one place i have long frames and thats in ENGM by Aerosoft but its not even official released for V3 so hard to blame anybody.

 

SLI is a keeper for single monitor flights for sure (still running driver 359.04 might need to upgrade soon again to latest version)

 

Michael Moe 

I jump on this topic, avoiding creating a new one.

 

I have two nVidia GTX770 in SLI with Prepar3D 3.1. During most of my test, it appeared that when SLI is activated I suffer from unstable framerate if framerate limitation is not set. If set to 25 fps (or 30 fps) I suffered from some stuterring. I never see one of the two GPU going higher that 50% load (check with EVGA PrecisionX tool).

 

To activate SLI, I just go to the nVidia control panel and set to "Maximise 3D Performance". Is there something else to do in P3D v3.1 I'm not aware of ? Something in the profil of Prepar3D.exe (nvidia recommanded, mode #1 or mode #2) ?

 

PS : nVidia driver version 361.44