September 30, 20178 yr 1 hour ago, onebob said: When selecting Vehicle, look at the Air Traffic Control Box.. Flight Number...type the ID of the airplane (default is zero. ) bob .... edit must be a bug somewhere but it works for now. Thanks, Bob. There was another poster over on the MU2 forum commenting about the same thing happening with his MU2. Stew "Different dog, different fleas"
November 19, 20178 yr Hi, I have exactly the same altitude hold problem mentioned before.It simply does not hold the altitude. Can anyone please advise?I run the C441 on P3Dv4.I purchased the C441 yesterday november18.
November 19, 20178 yr 2 hours ago, theophile said: Hi, I have exactly the same altitude hold problem mentioned before.It simply does not hold the altitude. Can anyone please advise?I run the C441 on P3Dv4.I purchased the C441 yesterday november18. On the FSW webpage there is the following suggested update for the C441. If you haven't tried it, it may be worth giving it a shot to see if it helps with the altitude hold issue by increasing the trim limit from 15 to 20 degrees (maybe the AP is running out of trim authority at high engine torque). The aircraft.cfg file is in your main C441 folder. Increase elevator trim range Until our next update changing this value in the Aircraft.cfg file using notepad will increase the elevator trim distance and this ensures that the autopilot will not use the entire range to keep the nose down during high torque. [airplane_geometry] elevator_trim_limit = 20.0 //Degrees Also, there is a 11Sept2017 patch available there to install the Com2/Nav2 radios if you are using a single GTN750 and the radios are missing from your C441 panel . http://flysimware.com/website/Cessna441.html Al
November 19, 20178 yr Thank you for the reply.But I have reinstalled the C441 and this appartently solved the problem. Again,thanks!
Archived
This topic is now archived and is closed to further replies.