In P3D with FSL or AS airbus i want to memorize a certain point (waypoint), about 40 miles out of LFMN, to excercise my approaches and landings there, so i can start each day or week, again from this same point with same airbus configuration, but in a way that i can alter visability and weather. So i think i will have to configure the complete flight once, proceed to this point, put on pause and then ? how to memorize this faze so i can  start over and over again beginning from this same point?

2 minutes ago, Pluto7777 said:

In P3D with FSL or AS airbus i want to memorize a certain point (waypoint), about 40 miles out of LFMN, to excercise my approaches and landings there, so i can start each day or week, again from this same point with same airbus configuration, but in a way that i can alter visability and weather. So i think i will have to configure the complete flight once, proceed to this point, put on pause and then ? how to memorize this faze so i can  start over and over again beginning from this same point?

Not sure what you mean with "memorize" but i would suggest to save the flight once you reached that point and then reload when needed. However, keep in mind that some complex aircraft addons dont really like loading a mid flight save and if there are significant weather changes (compared to the situation when you created the save) your aircraft may behave a bit funky until its settled with the new conditions

OK, thx, i will give it a try

If the "save" suggested by Woozie doesn't work, for example with complex aircrafts (panel state, FMC..), then you can check this addon https://www.fsipanel.com/

This addon is exactly what i want !!  Big thanks Simicro, i will buy this right now

You are most welcome, mate 😉

And this is a free alternative I have been using

http://planeman-fs.blogspot.com/2012/05/lord-of-landing-v17.html

 

Edited July 2, 20196 yr by willy647

9 hours ago, willy647 said:

And this is a free alternative I have been using

http://planeman-fs.blogspot.com/2012/05/lord-of-landing-v17.html

 

Does it work with p3d 4.5 ? 

14 hours ago, reecemj said:

Does it work with p3d 4.5 ? 

Yes

Hi,

Lola V1.8 is available on Avsim.

I'm holding on to v1.7 where you can set the weather. That option is gone in v1.8.