Using Fslab A320,After take off, the menu get stuck at climb flow.

 

Are you responding to the FMGS challenges as per the manual?  Ie., "Confirm clear rad nav... confirm copy active to secondary..."

You need to respond.

If you don't want to, though, there's a config option not to run the FMGS check at 10,000.

 

 

thanks I will try again and revert

I set the config option not to run the FMGS check at 10,000 but still the menu got stuck with a blinking climb flow. Must be another 'challenge' I'm not responding to? I completed the After Takeoff Climb Checklist including Below the Line confirmed seat belts off and then the climb flow starts blinking the only response FS2Crew will acknowledge is transfer of control PF to PM and back again. Can't initiate Approach Checklist or anything subsequent. Still blinking Climb Flow at engine cutoff.

????

Fred Ziker

Hi Fred,

I'll check it out.

 

Sorry to reopen this issue.  I just had this happen to me with 1.4.  I was cleared to 380, but had had the departure page set to 360.  I responded to all of the challenges, including 1000 below altitude (360), and continued on to 380.  After that I had the blinking climb flow through the rest of the flight.  I did however get the cabin secure intercom, and the automated GSX deboarding.

Just to let you know.

 

 

Again, I'm pretty sure you're missing this:

Are you responding to the FMGS challenges as per the manual?  Ie., "Confirm clear rad nav... confirm copy active to secondary..."

You need to respond.

There is an option to not run the FMGS check.

Set this option to Yes.

SKIP FMGS CHECK AT 10K: YES

Hi @byork

I have the exactly the same problem, even though I have selected

SKIP FMGS CHECK AT 10K: YES

before the flight. I have landed and the message is still flashing...

https://prnt.sc/zn931k 

Could you please help? The problem happens very often.

Thanks

Markos

 

 

Hi Markos,

Please make a video so I can see what you're doing.

Cheers,

 

Same here,  "Climb Flow" blinking, no solution found yet.   

 

I will just retry everything in a while.   But,  Why cant we just advance forward the stage as in other F2C versions? Well i cant do it using the  UP/DOWN arrows like before...   Just an option to think about...   Sometimes, for training, for mistakes etc, it is useful still id say....

Happy Flying!

Edited February 21, 20215 yr by Raphael_Chacon

It'd be best to have a video so I can see exactly what you're doing, but in the next update I can allow you to manually advanced past it in case for whatever reazon you get stuck in that flow.  That's a good idea.

Thank you again...

BTW i can confirm that i was able to perform normal checklist with my manual in the tablet.    I noticed it is kind of difficult to pronounce some words for the system(Like rudder, man flex XX SRS, and some others) and i really miss the briefing voice(read about the reason it is not in the manual, but i do miss it a lot).  In any case, yep, the flow works well from my side.

Looking forward for that update.   

Happy Flying and thanks for support! 😎

Edited February 23, 20215 yr by Raphael_Chacon