CARENADO CT182T SKYLANE G1000 released

[Arthur42417 193]

Version 1.2 Special Features

• NEW Full interior and exterior PBR (Redone completely).
• NEW 3D interior and exterior with MANY details.
• NEW customized FMOD sounds.
• Customized X-Plane default G1000.

Features

• Full VR compatible
• Specially designed engine dynamics for XP11.
• Flight physics optimized for XP11 standards.
• Physically Based Rendering materials and textures throughout.
• PBR materials authored with industry-standard software used by the film and gaming industries.
• Realistic behavior compared to the real airplane. Realistic weight and balance. Tested by several pilots for maximum accuracy.

Included in the package

• 5 HD liveries.
• 1 HD blank texture.
• CT182T G1000 Normal Procedures PDF.
• CT182T G1000 Emergency Procedures PDF.
• CT182T G1000 Performance tables PDF.
• CT182T G1000 Reference PDF.
• KAP140 Autopilot PDF.
• Recommended Settings XPLANE 11 PDF.

[Arthur42417 193]

 

[MSFS Ralf 149]

I hope they include the default G1000 in the Phenom 1000 soon.

[olderndirt 2,295]

'Thranda' does good work - wish it were the RG instead.

[Jeffg817 26]

Very nice Cessna 182 but it needs the GFC700 Integrated autopilot instead of the out dated KAP140.

Just my opinion as I have flown both version.

 

JeffG 

[Les Parson 99]

19 hours ago, Jeffg817 said:

Very nice Cessna 182 but it needs the GFC700 Integrated autopilot instead of the out dated KAP140.

Just my opinion as I have flown both version.

 

JeffG 

Agree but I'll bet there is very little chance of that happening. 

[haskell 298]

On 10/18/2019 at 6:29 PM, olderndirt said:

'Thranda' does good work - wish it were the RG instead.

Beware: Thranda was not involved in this one. So it may be typical "pre-Thranda Carenado" fare. 

[topcat_1952 20]

Purchased this when it was first released but finally got opportunity to try it out tonight. Using a X56 joystick and throttle, I have been having issues. It takes nearly full throttle to taxi and then the aircraft wants to not turn. When I finally got it underway for taxi, it kept pulling to the right. The final trial tonight, rudder steering would not work at all and even at idle the airplane kept moving through buildings, etc. Very frustrated at this point as I was anxious to get this airplane. I re-calibrated the joystick and checked config settings. The Laminar 172 worked fine so it would seem there is something in the files from Carenado.

Wondering if anyone else is having these issues?

Denny Knepper

Newville, PA USA

[Les Parson 99]

2 minutes ago, topcat_1952 said:

Purchased this when it was first released but finally got opportunity to try it out tonight. Using a X56 joystick and throttle, I have been having issues. It takes nearly full throttle to taxi and then the aircraft wants to not turn. When I finally got it underway for taxi, it kept pulling to the right. The final trial tonight, rudder steering would not work at all and even at idle the airplane kept moving through buildings, etc. Very frustrated at this point as I was anxious to get this airplane. I re-calibrated the joystick and checked config settings. The Laminar 172 worked fine so it would seem there is something in the files from Carenado.

Wondering if anyone else is having these issues?

Denny Knepper

Newville, PA USA

Did you upgrade to v1.2?

 

[topcat_1952 20]

No, but I'll check with the Carenado website for it. Thanks!