I wonder if that checklist items only plays if loading the cold and dark setup, because I always load with the engines running.

At any rate, my P3D V4 blew up so I only have V5 installed at the moment.

I'll try to replicate again in P3D V5 when Aerosoft released the V5 version.

In the meantime, just use the "skip" command if you get stuck on the APU Fire Test.

Correct!👌😏 I usually get started on the Cold State however, I have also tested it from the Turn Around State with FS2 Crew active and got the same result from the CL. Once the CL gets stuck the "SKIP" option on the MCDU disappears after the "APU Fire Test" call out and cannot execute anything beyond!. What I also have done its to switch it "Ready to Taxi" and beyond the CL Flow goes smoothly. So far the CL has gone through from A-Z smoothly with "FS2 Crew" panel disabled at the Configurator.🤔 

Can anyone else reproduce this?

🙄I seriously don't know who!..I have consulted Aerosoft many times and they keep pointing into the FS2 panel activated whats causing the interruption.🤔

Edited April 17, 20206 yr by fernandito1969

On 4/18/2020 at 4:11 AM, fernandito1969 said:

🙄I seriously don't know who!..I have consulted Aerosoft many times and they keep pointing into the FS2 panel activated whats causing the interruption.🤔

I spent some time testing trying to reproduce this...

If using the "Cold and Dark" state, the APU Fire Test check will occur.  (Previously I wasn't using Cold and Dark, that's why I never heard it).

However, the APU test will work regardless if FS2Crew is installed or not.

You have to wait about 40 seconds for the next checklist item to play after the APU Fire Test is done.

You have to wait 40 seconds if you have FS2Crew installed.

You have to wait 40 seconds if you do not have FS2Crew installed.

FS2Crew makes no difference.

So it's either a bug in the Aerosoft Airbus checklist or they're doing the 40 second pause deliberately.

Case closed!

 

Edited April 19, 20206 yr by byork