Jump to content


  • Content Count

  • Donations

  • Joined

  • Last visited

Community Reputation

0 Neutral

Profile Information

  • Gender
  • Location
  • Interests
    Golf, IT, Aviation

Flight Sim Profile

  • Commercial Member
  • Online Flight Organization Membership
  • Virtual Airlines

About Me

  • About Me
    Aeronautical Engineer with BA. NDT specialist
  1. Don't know if it's your problem, but my experience with VAT-Spy not starting is that it's already running. It minimises to the hidden icons section of the task bar. Did you check there? Ray
  2. Thanks, but I realised your intention
  3. Thanks for the reply. Thought I'd read that document, but was obviously swamped by the weather radar bit Thanks again Ray
  4. Hi everyone, I like to setup a flight for the NGX or 777 pre SP1 using PFPX online weather as a 'forecast', and Active Sky as 'actual' weather. I upload the FMC data, (& weather for 777), from PFPX, start ASN in live mode, and fly. No flight plan in ASN What changes do I have to make to this simple flow to take advantage of the new uplink features in SP1 please? Ray Copper
  5. Big green VOR/LOC at top centre of the ND
  6. Establish on LOC, then engage both autopilots immediately after arming APP works for me. Ray Copper
  7. http://www.nobleair.net/library/manuals/737NGX_Tutorial.pdf
  8. I have a i5-4670k cooled by h100i. It is clocked to 4.4GHz at 1.24v and during a four hour flight cpu temp does not exceed 50 deg C, and water temp 32 deg C therefore I would describe h100i as more than adequate? Ray
  9. Hi, I suggest you invest in a flight planning package then you could fly anywhere you wanted I started with FSBuild with the NGX. Works well and exports to the FLIGHTPLANS folder. I now use PFPX which is excellent but more expensive. Alternatively get a route from an online routefinder site & type in the waypoints? Ray
  10. Hi Arjen, I suspect your not pressing 'confirm' in FSUIPC. Try; In FSUIPC - Key Presses, Set, Ctrl-Shift-T, Custom Control, 70432, Parameter - 4, Confirm, OK That should save it for you? Ray
  11. Load the 'Long' panel state. That will have ground power connected and active. Most of the lights will not work on just the battery. Ray
  • Create New...