sharon mathew

could anyone join me for shared cockpit, 737

is anyone to share cockpit, please email, [email protected]

is anyone to share cockpit, please email, [email protected]

for fsx utility tileproxy beta 8. To install in win 8 64 bit. #1 Run these commands from an elevated command prompt (Win + x is nice for this): use cmd for this and right clickrun as admin bcdedit -set loadoptions DDISABLE_INTEGRITY_CHECKS bcdedit -set TESTSIGNING ON Reboot and you’re good. Take note there are two (2) D‘s in DDISABLE. Now install whatever you like. If you ever want to revers what you did, just run the opposite: do not run this before your finish tileproxy installation. This is to revert to original value. Let the first 2 codes be run then, run below codes if you want to get back to its original state and only after all installation procedures. bcdedit /deletevalue loadoptions bcdedit -set TESTSIGNING OFF #2 - Using Regedit ( some steps are repetition 1. Open Registry Editor. 2. In Registry Editor, navigate to the following registry key: HKEY_LOCAL_MACHINE\Software\Microsoft\Windows\CurrentVersion\Policies\System 3. Locate the following value (DWORD): EnableLUA and give it a value of 0. Note: As always, before making changes to your registry you should always make sure you have a valid backup. In cases where you're supposed to delete or modify keys or values from the registry it is possible to first export that key or value(s) to a .REG file before performing the changes. 1. Close Registry Editor. You need to reboot the computer for changes to apply. In order to re-enable UAC just change the above value to 1. #3. Advanced system start up. http://www.eightforums.com/tutorials/4924-advanced-startup-settings-boot-windows-8-a.html Move cursor to right bottom, click pc settings. Click general from left side tabs, click adv start up tab. Follow the prompt, until yo u get to a screen where it says disable unsigned drivers. Its not tough, for more info if you need call me [email protected], [email protected]. Or the man who showed me, Peter from UK. For further details on this. So , you will be pressing 7 or f7. To get started up from that screen, . remember it will be back on, if you reboot the system. So install tileproxy then and there before rebooting. Then, close down all firewalls. Make sure, all are closed , public, private. its important. Close down antivirus. Never notify the, uac. Controls. Then you are good to go for installing tileproxy. In case anything, people are there to offer their knowledge.