Jump to content

Archived

This topic is now archived and is closed to further replies.

Airbus

Vicplus Water Missing!

Recommended Posts

I decided to take a quick flight from Victoria Intl into the city to see the sights and scenery from the VICPLUS scenery package. To my surprise the water around the city and the docks was missing!! See attachment. I have not flown in this area for some time so I wonder if I have overwritten something. Thanks for any help resolving this problem. By the way I moved the high and low priority scenery to the top of my scenery.cfg file.Airbus

Share this post


Link to post
Share on other sites
Any chance your are using Orbx's FTX and left it enabled?
No, it is off. I enabled it just to see what would happen and there is still no water.Thanks for your help!Airbus

Share this post


Link to post
Share on other sites
No, it is off. I enabled it just to see what would happen and there is still no water.Thanks for your help!Airbus
Do you have UTX installed? If so, run its configurator again without making any changes to UTX settings.

Share this post


Link to post
Share on other sites
Do you have UTX installed? If so, run its configurator again without making any changes to UTX settings.
Thanks for your help! Unfortunately I do not have UTX.Airbus

Share this post


Link to post
Share on other sites
I decided to take a quick flight from Victoria Intl into the city to see the sights and scenery from the VICPLUS scenery package. To my surprise the water around the city and the docks was missing!! See attachment. I have not flown in this area for some time so I wonder if I have overwritten something. Thanks for any help resolving this problem. By the way I moved the high and low priority scenery to the top of my scenery.cfg file.Airbus
All you have to do, is run the VIC plus again...and then pick REPAIR. It will do its 'thang....and you will have VIC Plus running as it should. This was an issue when some went from SP1 to SP2. Land where water should have been. After running the VIC Plus setup again..and picking REPAIR...all was well, when running FSX/VIC Plus again.Mitch

Share this post


Link to post
Share on other sites
All you have to do, is run the VIC plus again...and then pick REPAIR. It will do its 'thang....and you will have VIC Plus running as it should. This was an issue when some went from SP1 to SP2. Land where water should have been. After running the VIC Plus setup again..and picking REPAIR...all was well, when running FSX/VIC Plus again.Mitch
Thanks Mitch! Got it fixed with the repair utility. Lovely place to fly!Airbus

Share this post


Link to post
Share on other sites

×
×
  • Create New...