Installed Vector V4 and P3D will not start?

[Howiefly13 30]

I just installed Vector V4 and P3d V3.5 will not start.

[Rwdogg 0]

Had the same problem..

 

Reinstalled vector 1.30 overtop

 

Then restarted P3D.. Took a while to start..

 

Then installed Vector 1.40

 

All seems fine now.

[Howiefly13 30]

Thank you

[vgbaron 3,627]

I rebooted a few times - seems ok now.

 

Vic

[edpatino 1,964]

Hi, all.

Suggest to report this at the ORBX forums.

Cheers, Ed

[Midnight Music 252]

No matter what you do in ORBX, always re-install the latest libraries, even with Vector. It seems to iron out some of the kinks in installations.

[virtualstuff 758]

I just installed Vector V4 and P3d V3.5 will not start.

 

Maybe first run the vector config tool and run auto.config plus press apply when done...

Works fine here :-)

[FlavioSSA 44]

Hi! In my case, the first time i ran P3D after Vector 1.40 install, it took AGES to start. I didn´t killed the process and finally it started. The subsequent times worked ok.

Maybe if you run p3d and forget it, it will manage to start?

[molleh 451]

Hi! In my case, the first time i ran P3D after Vector 1.40 install, it took AGES to start. I didn´t killed the process and finally it started. The subsequent times worked ok.

Maybe if you run p3d and forget it, it will manage to start?

 

I ran into the same thing. It stuck on 70% loading for about 3 minutes then finally finished and all was well.

[Gordon Hutchison 76]

Hi! In my case, the first time i ran P3D after Vector 1.40 install, it took AGES to start. I didn´t killed the process and finally it started. The subsequent times worked ok.

Maybe if you run p3d and forget it, it will manage to start?

 

I ran into the same thing. It stuck on 70% loading for about 3 minutes then finally finished and all was well.

 

Same here, first load after v1.40 update took ages, since then as normal.

[B777ER 2,486]

Sim probably is reloading bunch of new vector data the first time it's run. If it only happens after the initial install then no biggie.

[HUSSAR 272]

I installed Vector 140 after a fresh install of Prepar3D v3.3.5, I followed the FTX Global installation PDF but I noticed a quick error popup that disappeared before I could read it.  FTX Central started and I applied Global then downloaded and installed the ORBXLIBS.

 

This is the second time I installed up Prepar3D v3.3.5 as the first install of Global resulted in the sim crashing after a few moments.  The first time I ran Global I installed the LIBS directly from within FTX Central, again, I did see the error message which I could not read in time.  Interestingly, the installer did not ask for my license info.   

 

I don't think I uninstalled all the Orbx items as well as I should and that resulted in having to run the Orbx registry repair tool.  I will see if there is an error when I install Vector and the regions and post back.