March 31, 20188 yr Author 50 minutes ago, DJJose said: Do what you fear most. Fear is nothing more than a state of mind Then again! https://www.msn.com/en-ca/lifestyle/travel/relieved-pilot-kisses-ground-following-terrifying-emergency-plane-landing-in-florida/ar-AAvjJLT?li=AAadgLE&ocid=spartandhp Edited March 31, 20188 yr by SpiritFlyer
March 31, 20188 yr Author Not that there is a great chance the plane will blow up or I can not just reinstall again...
March 31, 20188 yr 29 minutes ago, SpiritFlyer said: Then again! https://www.msn.com/en-ca/lifestyle/travel/relieved-pilot-kisses-ground-following-terrifying-emergency-plane-landing-in-florida/ar-AAvjJLT?li=AAadgLE&ocid=spartandhp That video was all over the news. That CFI can now say that he practices what he preaches. MSFS
March 31, 20188 yr I had the same problem. I deleted my default flight, which I had set up prior to installing v4.2, and then created a new default flight. I haven't had any issues since then. Joel Murray @ CYVR (actually, somewhere about halfway between CYNJ and CZBB)
March 31, 20188 yr Oddly enough, without doing anything (that I’m aware of), on my flight today I had full functionality of the ATC menu...go figure! Dave Current System (Running at 4k): ASUS ROG STRIX X670E-F, Ryzen 7800X3D, RTX 5090, 55" Samsung Q80T, 64GB DDR5 6000 RAM, EVGA CLC 280mm AIO Cooler, Brunner CLS-E NG Yoke, Thrustmaster Warthog HOTAS & Stick, Thrustmaster TCA Quadrant & Add-on, VirtualFly Ruddo+, TQ6+ and Yoko+, GoFlight MCP-PRO and EFIS, Skalarki FCU and MCDU
April 1, 20188 yr Don't understand why users use a default flight. Seems to cause nothing but troubles. When I start P3D, I have it set so I am looking at the Scenario Startup screen, by checking the box that says show at startup. You can select starting place, aircraft, weather, etc. with zero problems. Works every time. Start P3D, go to Scenario/New and check the box that says "show at startup".
April 1, 20188 yr Author 1 hour ago, Bobsk8 said: Don't understand why users use a default flight. Seems to cause nothing but troubles. When I start P3D, I have it set so I am looking at the Scenario Startup screen, by checking the box that says show at startup. You can select starting place, aircraft, weather, etc. with zero problems. Works every time. Start P3D, go to Scenario/New and check the box that says "show at startup". Apparently you don't get it. Read why that was used as a procedural solution to a problem. This kind of post which deems others to be inexperienced newbies is a bit hard to answer diplomatically. But it is Easter, so Kind regards, Stephen
April 1, 20188 yr 29 minutes ago, SpiritFlyer said: Apparently you don't get it. Read why that was used as a procedural solution to a problem. This kind of post which deems others to be inexperienced newbies is a bit hard to answer diplomatically. But it is Easter, so Kind regards, Stephen OK, big boy.....
April 1, 20188 yr I experienced this problem as well. I'm currently using FSGlobal weather. If I initialize and load the flight, then start FSGlobal and load the weather file, ATC window works. Go figure.
Archived
This topic is now archived and is closed to further replies.