Skip to content
View in the app

A better way to browse. Learn more.

The AVSIM Community

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Problem w/PMDG738 after SU10 Update

Featured Replies

Have looked around to see if others have the same issue but haven't found any topics.

I loaded to PMDG 738 after updating to SU10.  The aircraft will load but once I get into the flight deck, I'm unable to see and of the gauges (PFD, MFD, etc.) nor can I manipulate any of the switches, knobs, etc.

BTW: PMDG 737 loads and runs fine.

 

Thanks for any assistance.

FoxTango

  • Author

Forgot to mention:

I did uninstall all PMDG 738 related items using the PMDG install app and reloaded after a computer reboot.  

FoxTango

My first flight in SU10 today was in the PMDG 738 and I had no problems except when I went to taxi--couldn't steer, couldn't brake, couldn't set flaps.  I thought perhaps controller settings were changed, but the weren't.  It was the need to do "ground maintenance" on the hydralics, then all was well.

Did you do the nV driver update yet?  I did, to new Studio version, and as I say, all's well.

Noel

System:  9900X3D Noctua NH-D15 G2, MSI Pro 650-P WiFi, G.SKILL  64GB (2 x 32GB) 288-Pin PC RAM DDR5 6000, WD NVMe 2Tb x 1, Sabrent NVMe 2Tb x 1, RTX 4090 FE, Corsair RM1000W PSU, Win11 Home, LG Ultra Curved Gsync Ultimate 3440x1440, Phanteks Enthoo Pro Case, TCA Boeing Edition Yoke & TQ, Cessna Trim Wheel, RTSS Framerate Limiter w/ Front Edge Sync.

Aircraft used in MSFS 2024:  Fenix A320,  Aerosoft CRJ, FBW, WT 787X, I-Fly 737 MAX 8, Citation Longitude.

 

  • Author

thanks.

Have not updated NVIDIA driver yet, waiting for the Game Ready driver.

I remember when I first loaded the PMDG738, I had MSFS in DX12.  I then read doing so might not have been a good idea.

 

FoxTango

after sim updates(fsx/p3d/msfs/etc.) u need to wait for the payware to get updated, is this your first sim?  

I have been flying the PMDG 737-800 in SU10 Beta for the past several weeks and haven't experienced any issue what so ever with the plane.

25 minutes ago, Beerz said:

after sim updates(fsx/p3d/msfs/etc.) u need to wait for the payware to get updated, is this your first sim?  

Sometimes you might, but the PMDG 738 is fine in SU10 with no update.  

Noel

System:  9900X3D Noctua NH-D15 G2, MSI Pro 650-P WiFi, G.SKILL  64GB (2 x 32GB) 288-Pin PC RAM DDR5 6000, WD NVMe 2Tb x 1, Sabrent NVMe 2Tb x 1, RTX 4090 FE, Corsair RM1000W PSU, Win11 Home, LG Ultra Curved Gsync Ultimate 3440x1440, Phanteks Enthoo Pro Case, TCA Boeing Edition Yoke & TQ, Cessna Trim Wheel, RTSS Framerate Limiter w/ Front Edge Sync.

Aircraft used in MSFS 2024:  Fenix A320,  Aerosoft CRJ, FBW, WT 787X, I-Fly 737 MAX 8, Citation Longitude.

 

1 hour ago, fortink said:

Have looked around to see if others have the same issue but haven't found any topics.

I loaded to PMDG 738 after updating to SU10.  The aircraft will load but once I get into the flight deck, I'm unable to see and of the gauges (PFD, MFD, etc.) nor can I manipulate any of the switches, knobs, etc.

BTW: PMDG 737 loads and runs fine.

 

Thanks for any assistance.

FoxTango

Typically a license issue. PMDG dot Com is where you can get it resolved.  You will need to open a support ticket, but before doing that you could puruse the PMDG forum for similar.

Edited by btacon

36 minutes ago, Beerz said:

after sim updates(fsx/p3d/msfs/etc.) u need to wait for the payware to get updated, is this your first sim?  

Haha, you tell 'em Beerz!    It's not Asobo's fault if all your add-ons no longer work after an update because it's the responsibility of the customer to anticipate when Asobo will break something, which in most cases is always.  

1 minute ago, hobart escin said:

Haha, you tell 'em Beerz!    It's not Asobo's fault if all your add-ons no longer work after an update because it's the responsibility of the customer to anticipate when Asobo will break something, which in most cases is always.  

Hey Hobo, you should learn a new tune or two. Your current one note song is quite flat.

-B

57 minutes ago, btacon said:

Hey Hobo, you should learn a new tune or two. Your current one note song is quite flat.

-B

Careful I don't steal your bird hat when you're not looking.    Then all the girls will flock to ME instead.   No pun intended.  

8 hours ago, hobart escin said:

Haha, you tell 'em Beerz!    It's not Asobo's fault if all your add-ons no longer work after an update because it's the responsibility of the customer to anticipate when Asobo will break something, which in most cases is always.  

Asobo haven't broken the 737.  It worked fine all thought the beta and now with the SU10 update.  So there must be a specific reason for the Op, and maybe a clash with another add-on.

The only thing I have seen that needed a little update was the PSM GTN750, and that is available now.

PS.  One thing I know about this forum - we have plenty of angry birds hats to go round!

Rob (but call me Bob or Rob, I don't mind).

I like to trick airline passengers into thinking I have my own swimming pool in my back yard by painting a large blue rectangle on my patio.

Intel 14900K in a Z790 motherboard with water cooling, RTX 4080, 32 GB 6000 CL30 DDR5 RAM, W11 and MSFS on Samsung 980 Pro NVME SSD's.  Core Isolation Off, Game Mode Off.

4 hours ago, bobcat999 said:

PS.  One thing I know about this forum - we have plenty of angry birds hats to go round!

LOL, true this.    😉

Archived

This topic is now archived and is closed to further replies.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.