AFTER FILING A FLIGHT PLAN USING PFPX AND USING GROUND OPERATIONS TO FUEL THE ACFT, I ENTER ALL INFO IN THE FMS AND GET NO V-SPEED INFO

Have you clicked on the LSK next to each Vspeed on the takeoff page of the FMC?

I had this once and I think it was to do with weight and balance as I was messing about with loads and fuel at the time. I readjusted my payload and it was fine again. Meant to look it up. Thanks for the reminder.

Have you clicked on the LSK next to each Vspeed on the takeoff page of the FMC?

 

Eric

He can't click the LSK next to each one if there not there.

 

Fernando

Maybe you have derated the thrust too much or are not using enough flaps for the weight of the 777.

 

Michael Cubine

 

 

Eric

He can't click the LSK next to each one if there not there.

 

I said this because I'm not clear from the post where he sees "No V-speeds".  If this is the message he has on the PFD speed tape, he may still have V-speeds in the FMC.

ADIRU is aligned?

The adiru was aligned

Gen I find the problem . I was entering all the information before the fuel load was completed.

To all you guys thanks for the help. I really appreciate

Make sure you select your runway departure parameter first before you get to that init param.

I've done this couple of times by not entering my runway departure and V speed are not there.

 

 

Kin M.

(Klax)

Do not derate your trust to much. Make sure you have a runway selected and weights. And also your cg