Calibrate Calibrate Calibrate your joy stick or your controller worked for me

Good evening,

I would like to thank you for this post
I recalibrated the two joysticks (yoke and pedals) and everything is working ok now

:smile:

*** My 4000th Post at Avsim....and lots of years enjoying this site - Thanks AVSIM ***

 

 

Just a question for you on how you calibrated because I could not get it to work.  Please confirm you are using FSUIPC.  Is the axis set as a "Send direct to FSUIPC calibration" or "Send to FS as Normal Axis" ?  thanks.

"Send to FS as Normal Axis"

 

greetings

OK thanks, will try that, I have it set as send to FSUIPC.

On 02/02/2017 at 1:41 PM, spesimen said:

 

a workaround that fixed it for me is disable this setting:

fmc->menu->setup->pmdg options->simulation->next page(2/10)->ctl input with AP on

 

cheers

-andy crosby

Fixed my problem cheers 

On 7/19/2017 at 0:26 AM, blakeburles said:

fmc->menu->setup->pmdg options->simulation->next page(2/10)->ctl input with AP on

Worked for me as well, but I wonder if Ctrl column and Ctrl wheel null zones would work better...maybe set them to a higher number?

I know that this thread is eight months old, but I just wanted to point out that I am suffering from this problem at the moment in the 747-400. It's interesting to note that it only started happening after I had reinstalled P3D v3.4 without installing FSUIPC. I am going to try disabling the "Control Input with AP on" setting.

Edited March 31, 20188 yr by Christopher Low

Problem solved.

This is the best solution I think too . My FFB stick is old and droops on release so  turning off (disabling) "Control Input with AP on" is perfect.

Disable ctrl input with AP on 

OR increase the Ctrl column and Ctrl wheel null zones just below ctrl input with AP on..

 

Solves the problem easily!!!