Jump to content

Majestic Dash 8 Q400 Patch With P3Dv2 Compatibility Released


Recommended Posts

Posted

Thank you Gordon ... I have a hunch, will report back.

 

Cheers, Rob.

  • Replies 94
  • Created
  • Last Reply

Top Posters In This Topic

Posted

Hi Rob, I had some screen shots linked from my skydrive folder, posted on Majestics forum, taken from my sim, which showed the vertical lines (spikes) problem. But also some texture flashing issues that I was having with my particular setup (using Van+). I had thought that the "spikes" were much worse on my machine, showing up in water, mountains, middle of the city, etc, but no where near a bridge. It seems now, that my scenery wasn't the issue, and that the issue is more common than I had thought.

 

  regards, Jazz.

Posted

 

 


It seems now, that my scenery wasn't the issue, and that the issue is more common than I had thought.

 

The Bridge issue (very tall bridges that raise up to the sky) is specific to an aircraft's view ... for example the F22 will not show the problem in any view.  However, the CS L1011 will show the problem in "Right Wing" view but not in VC ... I've reported to LM but seeing as it's aircraft dependent and view dependent I'm not sure who will end up fixing this problem.

 

As far as vertical spikes running to the sky, I've seen that issue but it has almost always been a case of my GPU getting too hot and/or graphics settings cranked up too high. I think I reduced that issue by dropping textures down to 1024, didn't OC my GPU, and maybe turned building density down ... not what you want to hear, but that solved those types of spikes ... if indeed we're talking about the same type of spikes?

 

Cheers, Rob.

Guest RWFeldman
Posted

 

 


As far as vertical spikes running to the sky, I've seen that issue but it has almost always been a case of my GPU getting too hot and/or graphics settings cranked up too high

 

I dont know Rob. My GPU isnt running hot, constant monitor and default settings, and it only occurs with the Q400.

Posted (edited)

http://1drv.ms/1AkOHob  

 

Onedrive containing 6 pics. I hope the link works.

 

Here are few screen grabs from CYVR and CYTZ (Toronto). The only time I see these type of spikes, is in the vc of the Q400. The 2D view(no panel) shows a normal scene without spikes or flashing textures. The flashing textures are very apparent in flight, as it seems that every mountain peak as far as the eye can see, is flickering.

  Jazz 

 

tested that the link is correct.

Edited by Jazzfan
Guest RWFeldman
Posted

Thought MJ had determined it was a Gauge causing this issue. They were going to wait a few days for any other issues then release a patch?

 

"we found a fix for this problem, but it needs a new gauge dll. We will wait a few days to see if there are any additional glitches that requires patching, and update the installer  and patch distributables"

Posted

 

 


vertical spikes running to the sky, I've seen that issue but it has almost always been a case of my GPU getting too hot and/or graphics settings cranked up too high.
  Yeah, I did have a modest overclock on my gpu (GTX670 Sig II FTW) of +150 mhz. I monitor the temps constantly via the G13 lcd. The highest it ever reached was 62 deg C. The default down clock temp is set at 90 deg C. As for grapics settings I have a very modest system by today's standards, as such, I don't go over board and run my graphics settings at normal/middle of the road for all settings.

 

  regards, Jazz

Posted

Downloading full installer now from Just Flight ... will install and see if I can duplicate.  Any particular airport? or Lat Long?

 

Cheers, Rob.

Posted

 

 


. Any particular airport? or Lat Long?
  Would you mind trying ORBX PNW, NRM? As that is where I see the worst case of texture flashing. 

 

   regards, Jazz.

  • Commercial Member
Posted

Well Folks.....

We are at present trouble shooting and testing the problem, as we attempt to find a resolution.  We though that we had a fix  but I spoke too soon.  We will let you know via our forums and F/book the status of our progress if this will take a bit longer than anticipated.

 

Best Regards

KROSWYND    a.k.a KILO_WHISKEY
Majestic Software Development/Support
Banner_MJC8.png

Sys 1:  AMD 7950X3D, NOCTUA D15S, Gigabyte Elite B650, MSI 4090, 64Gb Ram, Corsair 850 Power Supply, 2x2TB M.2 Samsung 980s, 1x4TB WDD M.2, 6xNoctua 120mm case fans, LG C2 55" OLED running at 120Hz for the monitor, Win11. Sys 2:  i7 8700k, MSI GAMING MBoard, 32Gigs RAM, MSI 4070Ti & EVGA 1080Ti. Hardware:  Brunner CLS-E-NG Yoke, Fulcrum One yoke, TM TPR Rudder Pedals, Yoko TQ6+ NEO, StreamDeck, Tobii Eye Tracker, Virpil VPC MongoosT-50CM3 Base with a TM grip
SIMULATORS: MSFS2020/XP12/P3D v5.4 & v6:  YouTube Videos

Posted

Confirmed issue in P3D V2.3 beta 2 also:

 

 

But on the plus side, the stutters are completely gone!  Smooth as silk ... really looking forward to the update to fix this.  I missed flying this aircraft.

 

Cheers, Rob.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
×
×
  • Create New...