All,

I'm unable to setup my yoke. Has anyone been able to do this? Would you mind sharing your profile?

 

Tim

Bump

 

It recognizes the yoke but none of the buttons work. Throttle doesn't do anything during the game.

Tim

Not even if you manually assign the buttons?

I feel your pain. I have JetMax and PFC hardware, neither of which is officially supported. I can't wait until Friday to see if it works. If not, I'm dead in the water and will have to go back to P3D until I get something else.

Edited August 17, 20205 yr by B777ER

If you have the good ole' basic "CH FlightSim" yoke, according to this post: https://www.avsim.com/forums/topic/579266-anyone-with-ch-yoke-in-beta/?tab=comments#comment-4284342 it works fine in FS2020 but you'll have to map the controls manually as that yoke has not been "pre-mapped" as many other more recently released ones in the sim. The following video will walk you through it easily:

Peripherals Setup in FS2020: https://www.youtube.com/watch?v=1DXdGaRgnhU

Be advised that the original poster of the forum thread linked above said he got all buttons and axis' to work with exception of the hat switch. I have the same yoke actually, and am waiting to download the sim tonight when it's available in my region. If you have success at mapping the hat switch let us know here ay? I will likely upgrade to the Honeycomb Yoke soon but i was curious to see if I can get by with the CH until I can get one.

I'm a relative newbie to all this stuff, so this could be something you've tried already.

I played Flight Simulator 2004 a lot about 15 ago with my CH Yoke and pedals and it was great back in the day.

I could never get into FSX as my CH controls were incredibly erratic in that game.

I decided to try and get FSX to work properly to get back into things before the launch of FS2020.

I downloaded the CH Control Manager program, used it to calibrate my products, and now my yoke and pedals are working fine, and I can enjoy FSX. The calibration within FSX did not work for me. Albeit a few of the buttons on the yoke don't work any more, I think because it's 15 years old and been battered about a bit. 

http://www.chproducts.com/Flight-Sim-Yoke-v13-d-705.html

I can’t seem to get mine working. I napped the axis for ailerons and elevator and it shows them moving in the settings menu but doesn’t actually move them on the aircraft 😞

Well I hope this is not an issue as I picked up a CH Eclipse and a hat is a must for me being right handed I cant deal with left handed hat yokes - hope this is not an issue

Anyone get the throttle work on the CH Throttle Yoke? I was able to manually map everything else.

 

Tim

Just now, SidekickUBT said:

Anyone get the throttle work on the CH Throttle Yoke? I was able to manually map everything else.

 

Tim

Tim you get hat to work ? thanks much

4 minutes ago, SidekickUBT said:

Anyone get the throttle work on the CH Throttle Yoke? I was able to manually map everything else.

 

Tim

What CH yoke do you use?

i can map them but can’t get them to actually control the flight control surface. 

Guess an xbox controller was top priority

This is horrible.How was this not found during testing?????????????????????????

Edited August 18, 20205 yr by SidekickUBT

1 minute ago, SidekickUBT said:

This is horrible.How was this not found during testing?????????????????????????

Well I guess we were not told only honeycomb and xbox controllers are allowed - you have to be kidding me - this is not going to end well - hope im wrong - this is ridiculous 

My CH yoke, pedals, and throttle quadrant work just fine..?