October 20, 20205 yr 1 minute ago, Flyfaster_MTN002 said: Have an older CH yoke and pedals, and I am sure it needs to be cleaned (or more). Do not get any twitching, however the right pedal looks depressed a bit when viewing down. At slow speed rudder works ok, but gets totally wild after about 20kts. Unfortunately the new Honeycomb replacement arrived DOA 😞 It's rudder controls that screw things up:) if the pedal is depressed.. make sure you have a dead zone which is greater than the pedal being down or it will be giving false input 🙂 Graham System specs... CPU AMD5950, GPU AMD6900XT, ROG crosshair VIII Hero motherboard, Corsair 64 gig LPX 3600 mem, Air cooling on GPU, Kraken x pump cooling on CPU. Samsung G7 curved 27" monitor at 2k resolution ULTRA default settings.
October 20, 20205 yr Just now, Moria15 said: It's rudder controls that screw things up:) if the pedal is depressed.. make sure you have a dead zone which is greater than the pedal being down or it will be giving false input 🙂 Graham Will give it a shot again thanks. Had tried this before, not great result. Maybe need more dead zone. SAR Pilot. Flight Sim'ing since the beginning.
October 20, 20205 yr 4 minutes ago, Flyfaster_MTN002 said: Will give it a shot again thanks. Had tried this before, not great result. Maybe need more dead zone. good luck.. I was having terrible trouble with the A/P disconnecting and diving to the left on releasing the A/P and it was all down to rudder settings 🙂 Graham System specs... CPU AMD5950, GPU AMD6900XT, ROG crosshair VIII Hero motherboard, Corsair 64 gig LPX 3600 mem, Air cooling on GPU, Kraken x pump cooling on CPU. Samsung G7 curved 27" monitor at 2k resolution ULTRA default settings.
October 20, 20205 yr 3 minutes ago, Moria15 said: good luck.. I was having terrible trouble with the A/P disconnecting and diving to the left on releasing the A/P and it was all down to rudder settings 🙂 Graham Amazing have the same issue - A/P clicks off almost immediately after engaged. Constantly. Did you figure out what caused that specifically? Edited October 20, 20205 yr by Flyfaster_MTN002 SAR Pilot. Flight Sim'ing since the beginning.
October 20, 20205 yr 13 minutes ago, Flyfaster_MTN002 said: Amazing have the same issue - A/P clicks off almost immediately after engaged. Constantly. Did you figure out what caused that specifically? Yeah.. my rudder conflicts were competing with the A/P and most of the time, the sudden rudder change was enough of a kick to disengage the A/P. Graham System specs... CPU AMD5950, GPU AMD6900XT, ROG crosshair VIII Hero motherboard, Corsair 64 gig LPX 3600 mem, Air cooling on GPU, Kraken x pump cooling on CPU. Samsung G7 curved 27" monitor at 2k resolution ULTRA default settings.
October 20, 20205 yr 1 minute ago, Moria15 said: Yeah.. my rudder conflicts were competing with the A/P and most of the time, the sudden rudder change was enough of a kick to disengage the A/P. Graham Unreal. Will remove the rudder and re-configure. Thanks! SAR Pilot. Flight Sim'ing since the beginning.
October 20, 20205 yr 12 hours ago, AmeliaCat said: yah i was only kidding slightly,,, if only there was a way to make forward visibility in that thing better,, i feel like i am in apollo capsule or something,, Raise your eye level (up arrow). Edited October 20, 20205 yr by Dillon FS2020 Alienware Aurora R11 10th Gen Intel Core i7 10700F - Windows 11 Home 32GB Ram NVIDIA GeForce RTX 4070 Ti Super OC 16GB - Pimax Crystal Light VR
October 20, 20205 yr If you're having the weird AP disconnects, spinning into a crash, etc. definitely check deadzones on all your axis inputs. It seems to be a new issue since the last sim update (or at least it made it worse if it wasn't already there). I've seen a number of posts about this being an issue recently. AMD Ryzen 9950X3D | Asrock X870E Taichi | Gigabyte Gaming OC 4090 w/EK waterblock | Full Custom Loop Cooling | Corsair Dominator Titanium DDR5-6000 | Samsung & WD NVME/SSDs | Phanteks Enthoo 719 | Seasonic Vertex Gold 1200W | Keychron Q5 Max | Corsiar Scimitar Elite SE Wireless | Honeycomb Alpha and Bravo | Logitech Pro Flight Pedals | VKB Gladiator Pro NXT L&R handed | MiniCockpit MiniFCU | Alienware AW34DWF | Asus PG279Q | Win 11 Pro
October 21, 20205 yr 7 hours ago, Flyfaster_MTN002 said: Have an older CH yoke and pedals, and I am sure it needs to be cleaned (or more). Do not get any twitching, however the right pedal looks depressed a bit when viewing down. At slow speed rudder works ok, but gets totally wild after about 20kts. Unfortunately the new Honeycomb replacement arrived DOA 😞 I have an old CH rudder pedals and I have to (forcefully) jam it full right rudder several times against the stop to get it to center properly. I also do once or twice full left for good measure too. I don't know if it's something wrong with the pedals or just a brute force "calibration" technique. If I don't do that rudder in the sim will be to the right of center when pedals are centered. Edited October 21, 20205 yr by N7470
October 21, 20205 yr 19 hours ago, AmeliaCat said: yah i was only kidding slightly,,, if only there was a way to make forward visibility in that thing better,, i feel like i am in apollo capsule or something,, Cushion ... buy some cushions. Its what we real world vertically challenged pilots need to do when seat height adjustment is insufficient or just unavailable. (it is either that or sideslip your landings like you would from the rear seat of an open cockpit biplane to see the runway on final 😄 ) Adding cushions may of course then mean you are unable to reach the pedals and need to get something like this: https://www.aircraftspruce.com/catalog/lgpages/cessna_pedalext_s_rpe_c.php Edited October 21, 20205 yr by Glenn Fitzpatrick
October 21, 20205 yr Cessna just needs to design better planes.. I dont think they know what they are doing. lol Its one of the reasons I love the Caravan,, the visibility is amazing.
October 21, 20205 yr 3 hours ago, flyinion said: If you're having the weird AP disconnects, spinning into a crash, etc. definitely check deadzones on all your axis inputs. It seems to be a new issue since the last sim update (or at least it made it worse if it wasn't already there). I've seen a number of posts about this being an issue recently. Thanks and yes it only started since the latest update. Basically A/P will not stay engaged (YD does however). Can see the input selects on the scoreboard, just the A/P kicks off every time. Checked the deadzones, and adjusted some for no good reason apart from this, same issue. Really frustrating! SAR Pilot. Flight Sim'ing since the beginning.
October 21, 20205 yr Commercial Member 13 hours ago, AmeliaCat said: Cessna just needs to design better planes.. I dont think they know what they are doing. lol Its one of the reasons I love the Caravan,, the visibility is amazing. Isnt the Caravan a Cessna tho? 😄
October 21, 20205 yr Fantastic video, this is how a tutorial video is done, not this cinematic word not allowed you often see on youtube, with quick cuts that are trying to hide incompetence. Learned a lot. Probably needs to be watched more than once to get all the nuances of the systems.
Archived
This topic is now archived and is closed to further replies.