How come the default flight plan we do on MSFS doesn't transfer to the FMC in the B787?  Do you guys have this issue.

Is this solvable?

If so How do I do it?

 

Edited December 26, 20205 yr by Manny

I experienced the same issue with the CJ4 today.

47 minutes ago, DMullert said:

I experienced the same issue with the CJ4 today.

If you have the Working Title CJ4 mods, you have to load the flight plan.

Without the mods, the flight plan should show up in the FMC.

It does for me..

2 hours ago, Manny said:

How come the default flight plan we do on MSFS doesn't transfer to the FMC in the B787?  Do you guys have this issue.

Is this solvable?

If so How do I do it?

 

I used the  default 787 today and the flightplan loaded fine. I only have livery mods and Robert Young's Bonanza though. Everything else is default

1 minute ago, Maxis said:

I used the  default 787 today and the flightplan loaded fine. I only have livery mods and Robert Young's Bonanza though. Everything else is default

Thanks Maxis. That gives me hope. I'll double check if I have some intrusion and get back.

I don't have any mods for 787. the only mod I have is for the A320. Hmmm.. so not sure why the Flight plan doesn't show up in my FMC. hmmmmmm.

The 787 I just started has the flight plan in the FMC. I guess when you start from an airport and arrive at the same airport like KDFW/KDFW t flt plan doesn't show.

Same thing happens, sort of, with the G1000 in the Cessana 172, Diamond DA62, G36 Bonanza, and G3000 TBM 920.  The flight plan shows up on the MFD but does not load into the autopilot. On the MFD, before take off, when I select the initial flight plan waypoint and press "Activate Leg" nothing happens.  The Autopilot shows a Direct to some waypoint off in the distance, which has nothing to do with the flight plan.  BUT.... the bearing and distance to the bogus waypoint is correct for the initial waypoint in the flight plan. 

However, once off the runway and nearing the first waypoint, while AP is on heading, the flight plan suddenly transfers to the AP and the flight plan initial waypoint suddenly becomes the active waypoint for the AP.  From then on everything works normally.

This started happening with the last update and with or without the working title mods. 

after the last update the 787 is broken

Default 787 is working fine for me. Flight plan loads from MSFS map and AP follows the route perfectly.  I currently only have the two Maccosim airports and Navigraph data in my community folder - nothing else.

CJ

2 hours ago, motishow said:

after the last update the 787 is broken

Is not broken, can you elaborate? It works for me.

I wish there was a good guide for the default 787, I tried a MS built flight plan from Seattle to Anchorage.....once I got to 27k feet, it started to porpoise and wouldn't get above that flight level, regardless of ap or not, also wouldn't go above 215k or .56 mach....uggg, I'll definitely classify as a 787 newb, but come on, it's not built as a level PMDG acft....

Edited December 28, 20205 yr by Virtualpilot65

The 787 is not broken.

She works well and is a very useable plane.

I didn't saw that flight Plan prob for me,

works always, to say i mostly plan my flightplans with LNM and Export them

over to FS.

This works beautiful to me..

cheers 😉