I need a little help from a few "upper atmosphere" experts. Here is a synopsis of my problem. This just started yesterday, and I havereached the limits of my troubleshooting abilities.After purchasing KFLL and GSX from FSDreamTeam, I set up a short circuit from KFLL to KMIA to practice varying flight scenarios in arepeatable manner. When I configured the airplane exactly as I needed, I saved the panel state using the FMC, as I have done ondozens of other occasions.When I pressed TOGA, everything looked good until I was airborne when the plane veered hard to the right. It was unrecoverable. Ireloaded the flight and saw the problem.The yoke was hard over right and would not move left. It still had elevator functionality, but no aileron control. I reloaded a couple ofother panel states and had no problem. I reconfigured the airplane from scratch, still had the same problem from the newly saved panelstate. I renamed the panel state. No help. I then manually deleted all the panel states that I had loaded in the past from FSX\PMDG\PANEL STATE. I reloaded a newly configurated panel state. No Joy. This problem is baffling me. It's become one of those quirksthat will hound me until it is resolved. When I loaded the reverse flight (KMIA KFLL), I had no problems.Any assistance will be greatly appreciated.

Have you tried to rekalibrate your stick?

Sometimes Unplugging & reconnecting your yoke/stick will fix this.

Actually this happened to me today too! I loaded a flight, and the ailerons were not working correctly!

Have you tried to rekalibrate your stick?

Sometimes Unplugging & reconnecting your yoke/stick will fix this.

Yes, I have done both those things. As stated above this problem only exists on this single panel state. All others work fine.

Edited February 5, 201214 yr by IFR7700

Funny, had the same problems here. The NGX banked hard to the right in the final with a crosswind of 7 knots. It reacted like a ultralight....

If you're using fsuipc did you try refreshing it by opening the menu & clicking ok?

If you're using fsuipc did you try refreshing it by opening the menu & clicking ok?

Just tried again, no help. Arrggggh

Still haven't solved the problem. This one is kicking my butt. Any other ideas? Ryan? Anyone?

Check aileron trim?

When the problem cannot be easily solved, save the flight, send all related files with a ticket at the support, it will be the best solution.

To Denis Trawick: Could you consider changing a color of your footer please... it is totally distractingRegardsCzarek

I have recently have the exact same problem. I reloaded my saved flight, and the yoke was moved in the full lock position to the right. It didn't respond to any of my inputs. Believe me, this is no calibration issue. I restarted FSX, reloaded a flight manually and it was all fine again. This is just one bug that the NGX has.

One more reason to send a ticket...It is probably a bug, maybe related to others where the aircraft goes crazy, but the support team must be aware of this, the ticket is the best way.

try switching off flight director.