Search the Community
Showing results for tags 'elite'.
Found 3 results
We are pleased to announce the release of our Elite Hardware Interface for X-Plane 10. This product allows you to use Elite Flight Controls and Avionics with X-Plane 10.20 or greater in 32bit and 64bit mode. There is nothing to assign, no buttons, switches etc. Everything is pre-configured. You can change the sensitivity of all flight controls to match your preference. The following Elite Hardware is supported: Elite Pro Panel II Elite Pro Panel SE Elite Standalone Throttle Quadrant (Multi or Single Engine and King Air) Elite Rudder Panels Elite AP4000 Avionics Stack Elite AP3000 Avionics Stack (Apollo GPS not supported) Elite COM/NAV Radio (2 modules supported for COM/NAV1 and COM/NAV2) Elite ADF Radio Module Elite DME Radio Module Elite Auto Pilot Module Elite Altitude Pre-Select and Audio Panel Module Elite Transponder Module Elite NAV/CRS/HDG Module Elite GNS430 Module Elite GNS530 Module (2 GPS modules supported for X-Plane GPS only) IMPORTANT! This software only supports Elite Devices with a USB Interface. Serial Devices (RS232) are NOT supported, even when used with a serial to USB converter! For more information, visit our product page.
I installed the Elite Hardware IF today AND purchased a license but am having major issues getting it to work with my Elite Pro Panel SE and AP3000. Running Windows 10. Attempting to run a Elite Pro Panel SE, Elite rudder pedals, & Elite AP3000 avionics panel. I first installed the Elite hardware drivers. I have Elite BATD FlightSim v8.6. All three hardware components work fine with the Elite flight simulator. When I bring up SimPlugin's Elite Hardware IF, all three hardware components show correctly in the status window. When I go CALIBRATE, the rudder pedals and toe brakes work. HOWEVER, the Pro Panel SE yoke, throttle quadrants, mixture and prop levers have no effect. The AP3000 doesn't seem to be recognized either. Second issue... When I start Xplane 10 and go to "equipment", I see a dialogue box that lists Elite hardware, but I see no where to calibrate the Elite controls; no controls responses either. SimPlugin installed in smame directory as Xplane 10. Any help would be appreciated. Dave
Hello everyone: Actually i am very disapointed because i bought an AP4000 console from Elite including the GNS 430 module. Going depper on the web, i found this GPS is only for Reality XP for FSX but my question is: How about of P3D customers?... Any plans to release the GNs 430 for P3D?... Thanks a lot.