Search the Community
Showing results for tags 'MCP'.
Found 4 results
Hello Avsim friends, I have the MCP, EFIS from Virtual Avionics all working great in p3dv4! But........I’m new on Xplane 11 and unable to get the hardware modules (MCP and EFIS) working. Do the modules work with the Xplane 11 (with the default planes)? My root cause and actions to try to solve the non functioning hardware: The icon of VA modules is green, the MCP is showing 0 signs in the displays but they do not interact with the simulator at all. What am I missing? Choosing a different profile in the configurator does not help. The status in the VA configurator program is showing xplane11 and showing the actual chosen plane like Cessna 182 or default Boeing 737. I downloaded the free 737 version from EADT installed it. After doing so, the VA configurator is showing the plain type info but again the MCP and EFIS are not working. When selecting the x737 profile in VA configurator it still does not work. The Windows firewall is off. So no problem with incoming or outgoing connections. Installed the 2.6 version (the VA plug-in is installed and active in Xplane). Installing 2.5 version does not help to resolve the problem. What am I missing? I'm lost.... please help. . Thank you. Mike
Tried to find a good place to post this so if this is not the best place, please advise... I have a new JETLINE system computer and new MCPPRO2, EFISPRO, COM, NAV and ATC modules that I am trying to get running. These units are daisy chained over Ethernet to the local LAN I have installed the drivers, made the addition to the PMDG 737NGX_Options.ini file, and am able to open FS_COM. However when I go to connect, I am getting the following error: "Run Time Error 40006. Wrong Protocol or Connection State for the transaction or request" I am running Windows 10 PRO 64 bit with P3DV4 and connected through my local LAN. My local LAN host is IP 10.0.0.1 so I have changed the IP number of the MCP to 10.0.0.40 and I am able to ping that address and get valid responses from the MCP. I have left the port at 4500 but have tried other ports with the same error response. Any experience with this configuration would be helpful...
Hi, I don't know if it is a bug or something I don't understand about the airplane, but I am not able to replicate the intended behavior of the autopilot during take off. SID is setup, I have LNAV selected on the MCP and armed on the FMA, AT is also ARMED on the FMA. So I select 40% N1 with my throttle, then I press the TOGA hotspot below the course select knob. On the FMA I expect to see N1, HDG/SEL and TO/GA but there is only the N1, the roll and pitch mods are empty. See the screen shots below, first one of before I press toga, second one after I press TOGA. N1 on the FMA is now THR HLD as expected but no roll or pitch mode have been activated by the TOGA. What am I missing? Thanks for any help, Ram Homier