Orbx Tapini gets affected with FSGlobal NG on mine :(

 

FSGlobal Support email also is not responding when I asked what BGLs make up the Papua New Guinea area so I can disable it. No replies for about a week now. Plus I cant find a support forum.

FG Global mesh messed up KDVT which is in the ORBX global airport pack, as well as KTUS which is default.  I ran the AFM2 elevation correction tool on both and it corrected it nicely.

13 hours ago, rlkjmt73 said:

I've had FSGlobal Next Gen installed for awhile now, and have not seen any problems in the FTX Regional airports, nor the North America/FTX Global airports that I purchased.  Could you tell me which airports are messing up, and I'll check them on my system?  I may not have the airports you're referring to though.

With a newborn haven't had the time I'd like to test ha.  Tapini (TAP) and its surrounding airports in the package, which is one of my favorites, unfortunately has floating/clipped objects all over the place.  When I get a minute I'll report back the others I've noticed problems at.

AFM2 doesn't have elevation correction option for the TAP area. Only hope is to find the BGL corresponding to Papua New Guinea. Or disabling the entire OCEANIA mesh :( 

Is this (OpenFlow2) still in beta phase?. It's been more than two months already?. I didn't have installed it yet, mainly because it could be unstable. Current users are Ok with it?.

Cheers, Ed

I asked at the Orbx forum yesterday what the status was of a non-beta version. No answer yet...

James

After Objectflow 2 install I cannot get KTVL objects or building to show anywhere for the life of me!  ANy ideas out there?    Its just a runway with no buildings!  I've double and triple checked objectflow's install . . . THanks for any help anyone can provide?

Did you try a Force Migration on FTX Central's Settings page.  Failing that, you should reinstall the ORBX Libraries.  Go to the directory where you have Prepar3d installed, then ORBX\User Documents\Versions and delete (or remove if you wish) the file "FTX_AA_ORBXLIBS.TXT.  Now return to FTX Central and you will be prompted to install the ORBX Libraries.

HTH,

Greg

P.S. I have KTVL installed in 4.1 with ObjectFlow 2 and all is well.  It works fine.  Good luck.

3 hours ago, Mark Niebauer said:

After Objectflow 2 install I cannot get KTVL objects or building to show anywhere for the life of me!  ANy ideas out there?    Its just a runway with no buildings!  I've double and triple checked objectflow's install . . . THanks for any help anyone can provide?

I had a similar problem. This may sound dumb or obvious,but when you are testing are you unpausing? I was testing another area from a saved flight but never unpaused. I couldn't see buildings etc. After unpausing there they were 

4 hours ago, Mark Niebauer said:

After Objectflow 2 install I cannot get KTVL objects or building to show anywhere for the life of me!  ANy ideas out there?    Its just a runway with no buildings!  I've double and triple checked objectflow's install . . . THanks for any help anyone can provide?

Open FTX Central, go to Settings, verify that Objectflow is checked, save the settings, and start P3D.

Thanks Bert!  It was actually a setting in the options/add ons of p3d. I checked the box and maxed out the slider to extremely dense. It all shows now. thanks