19 hours ago, Brandon01110 said:

has anyone else noticed that when you open your doors on the heli, it opens the doors of the multiplayer as well.  I noticed that last night when flying.

We have noticed this, but I also have never group flown with other aircraft capable of opening their doors to see if this happens across all aircraft.

19 hours ago, Brandon01110 said:

has anyone else noticed that when you open your doors on the heli, it opens the doors of the multiplayer as well.  I noticed that last night when flying.

I haven't noticed the doors but I have noticed if you don't have your engines running, a person in the air would have their engines off as well. I can't remember if thats common against other aircraft as well to be fair.

Edited April 4, 20215 yr by Zangoose

On 4/3/2021 at 2:15 PM, MediaHypeTrain said:

Popping in to recommend NeoFly if you want to add another layer of simplay to the H135.

 

NEOFLY is a great mod. Makes MSFS2020 even more fun

12 hours ago, MediaHypeTrain said:

We have noticed this, but I also have never group flown with other aircraft capable of opening their doors to see if this happens across all aircraft.

It happens with T45 as well, if you open your cockpit the others players with the plane open.  Probably never noticed, because none of the default aircraft open up.

 

 

Airbus H135 v0.82 is now up on Flightsim.to! Leave us a 5 star review!

0.82 changelog is as follows:

Add support for autorotation
Add support for legacy SimConnect axis mappings
Tweak various textures, messages and indications
Increase the bank angle of HDG AP mode when over 20kts.
Installed plush cockpit seat textures, collective/cyclic, glare shield.
Upgraded engine control panel
Added a tablet
rotor blur animation is fixed
rotor tilt animation added
AP MISC page buttons up/down will now repeat on hold.
Flight model: fuel burn adjusted
Load station and fuel tank points adjusted
Apron start will now have fuel valves closed, and subsequently the engine start switches will show OFF
Add POWER UP SELF TEST. It will run at startup and indicate success then disappear in about 90 seconds total.
Adjust sound to mitigate phasing
Disable copilot
Added a “check landing gear hotkey” warning if changing the flight mode more than 10 times in 2 seconds. This warning is intended to display for users who have incorrectly bound hotkeys for landing gear.
Add a couple README files about managing the copilot, downloading the EFB
EPU ‘white plug’ when available, EPU EICAS when available
EFB on all screens (commands only on the 3 primary displays for now)
You may now use the PFD Settings page to select the preferred Wind option for FND page, and the COM channel spacing may be set (2 digits vs 3 digits on COM frequencies)
Add hpa vs in/hg baro mode in PFD Settings. STBY not changed. Must exit sim cleanly for the setting to be saved for next time.
EFB may now be accessed from the Top-6 softkey on each display
FND/CLOCK now available on all 3 displays
Integrate GARMIN GTN 750 beta → https://pms50.com/msfs/downloads/gtn750-base-beta/
GTN750: Select Open GTN750 on the PFD Home page if installed. IMPORTANT: Avoid opening maps on the 3 main panels when using GTN750 to avoid a “max 4 maps” bug in the game that causes a CTD
Engine control panel revamped to use the yellow switches for OFF/IDLE/FLIGHT. Manual mode switches no longer used. Switch guards added.
You may now click the front pillar/strut to open the front left and right doors. the DOORS button will continue to open the rear cargo bay doors and the side sliding door.
Move (Cabin, Nav, Strobe, Beacon, Taxi, Landing lights to the overhead panel)
Move panel lights to the 6-pack of buttons
Remove all other 6-pack buttons
Move pitot heat to overhead
Move cargo doors switch to the overhead
Move fuel pump switches to the overhead (now two instead of one)
Move pitot heat switch to overhead
Speed up switches
Play some of the correct avionics sounds at startup
Move parking brake to OH
Move EPU connect/disconnect to an EPU softkey
Add a brightness control to 3 main displays
Add a power button to all 5 displays
Tablet is retracted by default
Aircraft systems page is deprecated
LOW NR warning aural below 97%
VMS NR gauge now goes to 100% for flight, stays at 100% until doing an auto
VMS N2 gauges now go red on failure
VMS Engine status IDLE/FAIL/STARTER at the top of page
Engine switches are wheel-only now
Add Animated cyclic control
Add Animated collective control
Two brand new liveries by @Crispy136
D-HYPE: a Black HYPE group livery (default)
D-HECB: Airbus Helionix corporate livery (soon to be default)
Baro on standby attitude indicator (knob only, not the display)
Click base of cyclic to hide it
Add red guards back to engine panel
Remove/hide LUM buttons from main displays (confusing/inop)
Tweak bladeslap sounds
Boost avionics sounds
Fix clipped ORI indicator in DMAP page

Lots and lots of improvements and changes. biggest list to date!

2 hours ago, MediaHypeTrain said:

Integrate GARMIN GTN 750 beta → https://pms50.com/msfs/downloads/gtn750-base-beta/

Extremely cool that the team has integrated the PMS5 GTN. 👍

I just download 0.82 and gave it a try, and the only way I could get it started was by Control-E. I will take it for another spin tomorrow, but as it stands right now, I think I will go back to 0.81. 🙂

@jpc55   

Engine Start: Engine Panel below MFD - switch (named Flight) - you have to use the mouse wheel !!! for move to start. With one switch both engines will start.

There is also no more FADEC switch, FADEC starts automatically with engine (I believe it was already in v. 0.81 too).

Have fun .....

 

BTW - just tried out the PMS50 GTN750 with the EC135 (and C172). Marveless .... all I have to say. 

27 minutes ago, stratone said:

(I believe it was already in v. 0.81 too).

With that information, I will go back to it. In it I controlled each turbine separately and also the FADEC. At times I will land and shut down the FADEC and sit there at an idle, then turn it back on and takeoff.

Edited April 7, 20215 yr by jpc55
Changed a word

Using the middle mouse wheel over the engine scroll switch does work to start. Thanks

Edited April 7, 20215 yr by Isaiah53six

Airbus H135 v0.83 is now up on Flightsim.to! If you haven’t already, please give us a 5 star review!

• Animated torque pedals.
• Added analog compass.
• Added a number of detail elements to the cockpit.
• Added fire extinguisher.
• Added euronav control panels, keyboard outlets (inop).
• Fixed engine control panel texture.
• Upgrade lower radio, AP, systems panels between Capt and FO seats.
• Install carpet.
• Fix texture on base of cyclic.
• Add emergency annunciations / engine control panel (inop).
• Collective control animation now works on the ground with engines IDLE or OFF.
• D-HECB is now the default livery
• Switch added to overhead panel to remove the windshield in rain to prevent glitching
• Download: Airbus H135 Helicopter Project » Microsoft Flight Simulator

Download: https://flightsim.to/file/8970/airbus-h135-helicopter-project

2 hours ago, MediaHypeTrain said:

Airbus H135 v0.83 is now up on Flightsim.to! If you haven’t already, please give us a 5 star review!

• Animated torque pedals.
• Added analog compass.
• Added a number of detail elements to the cockpit.
• Added fire extinguisher.
• Added euronav control panels, keyboard outlets (inop).
• Fixed engine control panel texture.
• Upgrade lower radio, AP, systems panels between Capt and FO seats.
• Install carpet.
• Fix texture on base of cyclic.
• Add emergency annunciations / engine control panel (inop).
• Collective control animation now works on the ground with engines IDLE or OFF.
• D-HECB is now the default livery
• Switch added to overhead panel to remove the windshield in rain to prevent glitching
• Download: Airbus H135 Helicopter Project » Microsoft Flight Simulator

Download: https://flightsim.to/file/8970/airbus-h135-helicopter-project

Wondering if there will be a US medical livery available? 

 

Edit: nevermind I found some on the website

Edited April 8, 20215 yr by Isaiah53six
Answered my own question

How do you get the GTN750 working?

@captain420 The instructions are in the pinned messages of the feedback channel on their Discord server.

Martin