1 minute ago, MSFLYER5856 said:

Can anyone tell me the KB command for reverse thruster on this plane or what event turns on the reverse thruster.

You can assign a key.. I have F2 assigned.

Here is a fast review and nice take oof:

https://www.youtube.com/watch?v=5u1DGS0dxHQ

5 minutes ago, sd_flyer said:

Again I understand that Daher license this product and provided documentation. But I highly doubt they do any testing. MSFS is entertaining product not FAA approved sim.

Alex, the head of Sim Works studio discussed this and the trim characteristics in a launch Twitch stream with TheFlyingFabio today, if you have the time, take a look.

It was entertaining and informative.

3 minutes ago, Bert Pieke said:

You can assign a key.. I have F2 assigned.

This may be my first rverse thruster plane - what is the command in the setting to spare me from searching through them.

1 minute ago, Simple B said:

Alex, the head of Sim Works studio discussed this and the trim characteristics in a launch Twitch stream with TheFlyingFabio today, if you have the time, take a look.

It was entertaining and informative.

word not allowed 🙂 you took my punch line lol. I was just waiting for him to walk into that trap. 

11 minutes ago, sd_flyer said:

Some of them blurry but majority are ok. Here is closer look.

Ok thanks...must be my eyes then lol. When i load up the 172 though as a comparison the textures look noticeably sharper.

Edited December 17, 20214 yr by Ray Proudfoot
Image removed

4 minutes ago, MSFLYER5856 said:

This may be my first rverse thruster plane - what is the command in the setting to spare me from searching through them.

It is called Beta mode on the plane..

6 minutes ago, Simple B said:

Alex, the head of Sim Works studio discussed this and the trim characteristics in a launch Twitch stream with TheFlyingFabio today, if you have the time, take a look.

It was entertaining and informative.

No I didn't watch. But I sent screenshot to developer and it's under investigation. Developer seems very nice and forthcoming.

By the way I used to a big fun of Hot Start TMB900 for X-plane 11. It used to be my number one GA aircraft! 

9 minutes ago, Brownshortz said:

Ok thanks...must be my eyes then lol. When i load up the 172 though as a comparison the textures look noticeably sharper.

May be Asobo had a better 3d scanner! LOL

Here is another cool vid from RL.

 

42 minutes ago, Bert Pieke said:

It is called Beta mode on the plane..

Forgive my ignorance, so I should see Beta mode listed in the keybindings in MSFS Options -> Controls ?

You have to make sure you are not over the CG limit, you need elevation and rudder trim. This is the way

Edited December 17, 20214 yr by fogboundturtle

3 hours ago, DMullert said:

Hello Gang!

For those of you that purchased the Kodiak, is anyone experiencing an immediate STAL STALL STALL on take off, followed by a hard roll to the left and the ground?  I can't figure that out to save my life and wanted to inquire about this before posting a ticket with their support folks.

Thanks!

 

Got the same here.

rechecking settings.

On climb out rolls hard left & into the ground.

3x so far.

Using the no cargo pod, Tundra tire version.

Never had any other aircraft in MSFS do that.

T45

Edited December 17, 20214 yr by Treetops45

2 minutes ago, Treetops45 said:

Got the same here.

rechecking settings.

On climb out rolls hard left & into the ground.

3x so far.

Using the no cargo pod, Tundra tire version.

Never had any other aircraft in MSFS do that.

T45

That's because other aircraft are "easy mode" in MSFS. If you add the proper amount of rudder trim and elevation trim and don't takeoff too quick, you will be fine.

19 minutes ago, MSFLYER5856 said:

Forgive my ignorance, so I should see Beta mode listed in the keybindings in MSFS Options -> Controls ?

Just looked... I have F2 assigned to "Decrease Throttle".

After I pull back the throttle to idle, holding down this key moves the throttle into Reverse/Beta range.