Curly

On my Saitek yoke I have a button assigned for spoiler open/close. By coincidence the pod appears or disappears when this is pressed... Try assigning a button for spoilers and see if this applies.

I do not see the FSX flight plan in the FMS... Is it in there somewhere ?

Terrific solution ! My Saitek modules (BIP, Radio panel, Switch panel and AP control) even though all connected to powered hubs would freeze when I loaded sceneries and UT2 to high settings. Just flew the PMDG 737 from KOAK to LAX with high settings on traffic and scenery and all went smoothly with none of the previous freeze or CTD. Thank you

I checked my rate of climb with: with a 1600 fpm indication I only get a 1000 fpm real climb. The simulation rate is normal the pitot heat is on and the altimeter setting is correct. There is a very strange feeling of something holding back the plane. Acceleration on take off is also very slow. My Flight One Mustang is very hot and realistic compared to this one.

Get the Waco biplane from Alabeo. Beautiful variants and fun to fly.

Thank you bert. Got them all now .Beautiful graphics !

I thought we would get the liveries of Air Canada, Air New Zealand etc as seen in the development period pictures. Are these accessible somewhere ?

Absolutly voluptuous !!! I think my F1 Cessna Mustang will have to rest for a while...

The control knobs turn bluish when I point the mouse over them but the wheel has no effect on their movement. I can turn the knobs with my Saitek multi panel or radio controls but no effect at all with the mouse. I have all the Carenado planes and this is the only one with the problem. Everything else works: NGX, A2A, Real Air Etc. Wish someone had a solution because Carenado could not offer one. I have tried disconnecting the Saitek panel but no difference... Thanks for any suggestion

Thanks to all of you guys. That was very helpful ...

After installing all of ORBX western sceneries (Pacific northwest,Central Rockies,etc.) , all my lakes and rivers in eastern Canada and US have disappeared. Even when selecting FSX in ORBX control panel I have only land where water used to be. I have reset textures in UT Canada and US also in GEX Canada and US and still no changes . I have registered in ORBX forum but find it impossible to get access. I am about to remove all of my FSX and sceneries and aircrafts because of this awful mess. I have work for a week reloading all of this. If anybody can help before I erase everything I thank you in advance ...

Got the plane and it is beautiful. There is a disproportionate tiny pilot figure which is stuck under the glass canopy when it is open. The pilot looks a dwarf lost in a huge plane.

The announcements can be turned off by the switch of the TCAS at the lower right corner of the climb rate indicator. When it is on you will see a blue indicator of the range of the warnings

Sorry. My enthousiastic mistake... I will substract one hundred and fifty. It is a 200 indeed

Have a look at the latest photos of work in progress. The cabin is gorgeous and you can take a distant peek at the panel. I take so much pleasure flying the C90. This will double the fun !!!

The hook is to catch an arrester cable stretched across the last section of the runway . It was connected to an undergroud hydraulic drum apparatus that would stop the aircraft in case of an emergency.

Volume was at maximum with A2A environment.

Scare yourself and try a full power take off with one or both little side windows left open ...

I think that the infernal beep is to tell you that the landing gear is not down as you are pulling the throttles to idle.

My PFD goes black with red fail indicators about 15 minutes in flight. Did not have this problem before SP1 also.

Same thing happened to my PFD on the last flight. I am running on SP1 now and this did not happen before on dozenz of flights.

I would like to apply your fix but when I open the sound folder all the individual files are revealed and no sound.cfg is seen. In the B90 lite section ther is a .cfg but it refers to alias B90. sound.cfg. I am using Windows 7 64. Can I reduce all the files under one denomination of .cfg in the original folder ? Thanks for any help

I suggest you go to the AVSIM review of the P51s by Chris Kiehl. He has contacts within the company. [email protected]>

Things have been settled now. I finally received my validation. They claim that they had problems with their security codes and that their site was off the air for a while.The planes are just beautiful and the souds of the Merlin engine very realistic. These B and C Mustangs plus the A2A P51D are the complete experience.Do not hesitate if you want these. They were worth the trouble and the vendors are very concerned about their reputation.

This is the mail system at host localhost.webmetics.com.I'm sorry to have to inform you that your message could notbe delivered to one or more recipients. It's attached below.For further assistance, please send mail to <postmaster>If you do so, please include this problem report. You candelete your own text from the attached returned message. The mail system<[email protected]>: user unknown. Command output: Invalid user specifiedThis is where I realise I habeen ''Roally Had''