Jump to content

Sign in to follow this  
rwalls

Aerosoft CRJ Available for P3D v5

Recommended Posts

11 minutes ago, Dreamflight767 said:

Is this update only for v5?

It's for both versions but there are separate installers.

Share this post


Link to post
5 hours ago, JasonPC said:

It's for both versions but there are separate installers.

Thanks.  Can't figure out why I can't find it.


Aaron Ortega

Share this post


Link to post
11 hours ago, Dreamflight767 said:

Is this update only for v5?

I remember them stating the fixes were general so I assume they went into v4 as well


Shom

[P3D v4.5 HF2 running on Win 10 Pro, i7-9700K, EVGA 1080Ti, Crucial 2666 16GB, 2 500GB Samsung EVOs 850/860]

[FSLabs A320, PMDG 737 NGXu, PMDG 777, AS CRJ Pro, CS 757 iii, Fly The Maddog X, Majestic Dash 8, QW 787, TFDI 717, AS Airbus ProFeelthere E175/195 v3]

Share this post


Link to post
7 hours ago, Dreamflight767 said:

Thanks.  Can't figure out why I can't find it.

Where did you purchase it? Might want to post a note on the Aerosoft CRJ support forum. Perhaps they can give the vendor a nudge to get the installer updated.

If you purchased the aircraft directly from Aerosoft, the new installer will appear in your shop account immediately. They normally send out updated installers to their authorized resellers the same day they post it on their own system. In my experience SimMarket is usually very quick to update - not sure about other vendors.


Jim Barrett

Licensed Airframe & Powerplant Mechanic, Avionics, Electrical & Air Data Systems Specialist. Qualified on: Falcon 900, CRJ-200, Dornier 328-100, Hawker 850XP and 1000, Lear 35, 45, 55 and 60, Gulfstream IV and 550, Embraer 135, Beech Premiere and 400A, MD-80.

Share this post


Link to post

Thanks everyone.  I am trying to resolve with the help of Aerosoft.  Issue appears to be with the vendor.  If no solution is reached, I'll share which vendor I used to help everyone avoid.

Thanks!  


Aaron Ortega

Share this post


Link to post

What performance are you guys getting in v5?  It’s my worst performer now. 


9700k | Maximus XI Hero| 32gb DDR4 3000 | 1080Ti 11GB | 1tb EVO Plus 970 and 500GB M2+3TB HDD | 43" Samsung X60R 4k and 2  22" monitors | Corsair RM750x |  240MM AIO.| MFG Crosswind | T16000M Stick | Saitek Throttle Quad | Skalarki MCDU and FCU | Saitek Radio Panel

Share this post


Link to post

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.  


Aaron Ortega

Share this post


Link to post

Sounds about par for the course with this addon, it's had LNAV issues from the very beginning 😅.

Share this post


Link to post
2 hours ago, Dreamflight767 said:

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.

You could try setting the Autopilot Disconnect Sensitivity to Low in the EFB options. It certainly stops issues where high winds can cause the AP to disconnect.


Pete Gordon

Prepar3D V5 | ASUS TUF Z370-Plus | i7-8700k | 32GB G.Skill Ripjaws Series 5 DDR4 2666MHz | Aorus GeForce GTX 1080 | Cooler Master MasterLiquid 120 | Samsung 960 EVO 500 GB | Samsung 970 EVO Plus 1TB

 

 

Share this post


Link to post

my biggest niggles the displays are blurry and EFB too dark ad dusk dawn. Even with the light textures cockpit too dark and not good on FPS


Colin hodds

I7 9700K,nvidia 2080 ,ssd ,32gig 3200mhz ram ,win10,prep3d

Share this post


Link to post

Yep. It’s fine until I turn the battery on then my locked 30 will stutter a little 


9700k | Maximus XI Hero| 32gb DDR4 3000 | 1080Ti 11GB | 1tb EVO Plus 970 and 500GB M2+3TB HDD | 43" Samsung X60R 4k and 2  22" monitors | Corsair RM750x |  240MM AIO.| MFG Crosswind | T16000M Stick | Saitek Throttle Quad | Skalarki MCDU and FCU | Saitek Radio Panel

Share this post


Link to post
2 hours ago, retepnodrog said:

You could try setting the Autopilot Disconnect Sensitivity to Low in the EFB options. It certainly stops issues where high winds can cause the AP to disconnect.

Thanks.  But from my understanding, that setting is only if you move the yoke.  I didn't see one for sensitivity in itself.


Aaron Ortega

Share this post


Link to post
3 hours ago, Dreamflight767 said:

Thanks.  But from my understanding, that setting is only if you move the yoke.  I didn't see one for sensitivity in itself.

I thought the same, but reading the Aerosoft forums, the recommendation for AP disconnecting due to wind gusts, etc. was to set the sensitivity to low and since I've done that, the CRJ rarely strays off course.


Pete Gordon

Prepar3D V5 | ASUS TUF Z370-Plus | i7-8700k | 32GB G.Skill Ripjaws Series 5 DDR4 2666MHz | Aorus GeForce GTX 1080 | Cooler Master MasterLiquid 120 | Samsung 960 EVO 500 GB | Samsung 970 EVO Plus 1TB

 

 

Share this post


Link to post
21 hours ago, Dreamflight767 said:

I was finally able to install latest build in v4.5 w/ all HF.  Airplane won’t stay on flight plan.  Drifted and flew way off course twice.  

 

18 hours ago, Prpn said:

Sounds about par for the course with this addon, it's had LNAV issues from the very beginning 😅.

I was also in the beta and the CRJ surely received some improvements.

It is still a bit bad in performance and it somethimes does indeed do some strange turns but the best way to adress this issues is if you would give more informations about the situation encountered e.g: which CRJ, what livery, AIRAC, FPLN, etc....maybe also a short recording of the "error"... so that others (as me e.g.) can try to reproduce it.


Gerald K. - Germany

Core i7 4790 / ASUS H87-PRO / MSI GTX 970 / 16 Gb RAM Corsair Vengeance 1600 / 24" Full HD.

WIN 10 HOME 64 + P3D v4 + GEP3D + UTX Europe + FS Global Ultimate NG + ORBX Trees HD + ASP4 + ASCA/SF3D + ENVTEX + ENVSHADE + GSX + EZCA + (EnvForce).

"Flightstick" = X56 HOTAS RGB Logitech

Share this post


Link to post
Posted (edited)

It's harder on FPS and a steeper learning curve then say the QW787. But its still a joy to fly. I would recommend it, but only if you have a 1080ti or above v-card. Flight dynamics, sound set and visuals are all great in my opinion.

Edited by TurboKen

Flight Simulator - P3D V4.5/V5 | Operating System - WIN 10 | Main Board - GIGABYTE Z390 AORUS PRO | CPU - INTEL 9700k (5.0Ghz) | RAM - VIPER 32Gig DDR4 4000Mhz | Video Card - GIGABYTE RTX2080 OC Monitor - DELL 38" ULTRAWIDE | Case - CORSAIR 750D FULL TOWER | CPU Cooling - CORSAIR H115i CUSTOM LOOP W/ DUAL 280MM RADIATORS | Power Supply - EVGA 1000+ 

 

Share this post


Link to post

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
  • Tom Allensworth,
    Founder of AVSIM Online


  • Flight Simulation's Premier Resource!

    AVSIM is a free service to the flight simulation community. AVSIM is staffed completely by volunteers and all funds donated to AVSIM go directly back to supporting the community. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. Thank you for your support!

    Click here for more information and to see all donations year to date.
  • Donation Goals

    AVSIM's 2020 Fundraising Goal

    Donate to our annual general fundraising goal. This donation keeps our doors open and providing you service 24 x 7 x 365. Your donation here helps to pay our bandwidth costs, emergency funding, and other general costs that crop up from time to time. We reset this goal every new year for the following year's goal.


    22%
    $5,550.00 of $25,000.00 Donate Now
×
×
  • Create New...