48 minutes ago, Wise87 said:

I'm getting great performance flying the Fenix Airbus. Below is what gives me a solid 30 FPS the entire flight regardless of the scenery, weather or AI models around me. Maybe this will help others. I use to set my Sony 43in 4K TV to 30hz for the longest time.  That is what I have used in P3D for years. Now I run it at native 60hz and make my adjustments else where. My TV does not have G-Synch so this is not a key to my settings. Something new I have done is turn on my Integrated GPU which for me is the Intel UHD Graphics 630, so the Fenix A320 displays can run off of it and leave the rest of MSFS2020 running off my 3090. I tried the other Render Displays On in the Fenix App but my FPS would flux slightly. Except for the Fenix, nothing else uses the Integrated GPU so when I'm flying planes like the PMDG the IGPU load is 0%. My GPU load for my 3090 will range from 50% to 99% depending on the scenario.

I know some of you are looking for as many FPS as possible but I find 30FPS in SIM is very smooth. When I fly with others online they will report stutters and pauses as there frame rate fluctuate while I have a smooth experience and my FPS remain a solid 30. Maybe my settings will help someone out. 

My Settings are as followed:

Nvidia Control Panel I only change Power management mode to Prefer maximum performance.

In MSFS2020 I leave V-Synch ON and changed Frame Rate Limit from default 60 to 30. 

I've loaded up at Chicago Midway Airport (KMDW) which is a VRAM hog but my 3090 can handle it with no problems. Most other times my VRAM is between 8mb -  10mb depending on the aircraft, scenery and weather. 

Same experience w 3080 and 5900x. The MS vsynch gives the smoothest experience @30 FPS. would like like higher? sure but I will take this all day. 

I’m running a 5950XT, 64gb and 3090. No 2nd GPU and am getting 25-30 fps in intensive scenario’s and 35 fps in low intensive area’s.
The Mainthread is mostly taking around 25-27ms, compared to the 17ms posted above.
There’s not much difference between running Fenix on CPU or GPU on my system.
Nvidia is set to max performance, vsync on 60fps in MSFS.
 

Still very happy with the Fenix. They’ve put a lot of effort into this and it shows!

24 minutes ago, Andre92 said:

I’m running a 5950XT, 64gb and 3090. No 2nd GPU and am getting 25-30 fps in intensive scenario’s and 35 fps in low intensive area’s.
The Mainthread is mostly taking around 25-27ms, compared to the 17ms posted above.
There’s not much difference between running Fenix on CPU or GPU on my system.
Nvidia is set to max performance, vsync on 60fps in MSFS.
 

Still very happy with the Fenix. They’ve put a lot of effort into this and it shows!

Why post all this detailed information but not your screen resolution which majorly impacts FPS? 🙄

2 hours ago, wiler said:

settings high LOD 200. I can get 45-50 FPS that stutters, what good is that?  thats why for me, smooth 30FPS is better then a stutters mess 45/50.  

Uh you said before you "can barley squeek out smooth 30FPS". Now you are saying you actually have 45 to 50, but decided rather upon smooth 30. What is it now? Barely 30 or easily 45?

1 hour ago, wiler said:

Same experience w 3080 and 5900x. The MS vsynch gives the smoothest experience @30 FPS. would like like higher? sure but I will take this all day. 

Well I have VSYNC on and locked 30FPS it's butter smooth not a single stutter, running most settings ultra (with complex aircraft) with an 17-12700K and RTX3080 and 32 gb ram...

Can throw anything to the system and it never goes below hence a lot of headroom... Due to no stutters the perceived / speed smoothness is actually pretty fast as running 50 > 70 fps with a a few stutters...

Best decision I made in a long time to go this route :-)

Edited May 22, 20224 yr by awf

 

Stupid question sorry but does anyone know how ACARS works/how I can clear 'COMPANY MSG'?

Just now, dolbinau said:

Stupid question sorry but does anyone know how ACARS works/how I can clear 'COMPANY MSG'?

MCDU MENU -> ATSU -> AOC -> RCVD MESSAGES -> click on message. This will make the notification disappear. As for ACARS in general, you don't have to use it, unless you do CPDLC; flight plan uplink, METAR and ATIS you can get via the EFB.

My performance looks very good what i tested so far, i'm very satisfied, my setting are not at Ultra at all, means you should adjust the MSFS settings to the Fenix A320.

I did not change anything about that settings for the Fenix because they are always set that way..

My Rig will be 5 years old this year at Christmas, so not bad for me. See my specs, realy not top notch but it is working..

 

Very good bird IMO 👍

 

cheers 😉

Any comparison with the MaddogX?

It performs a little lower than PMDG737 on my system.

Michael Moe

@Wise87 what application gives you this display? It's slick and I'd like to get it!

https://m.imgur.com/K6Kwlug

 

2 minutes ago, odourboy said:

@Wise87 what application gives you this display? It's slick and I'd like to get it!

https://m.imgur.com/K6Kwlug

 

I’m using MSI Aterburner. I only use the overlay features. 

Edited May 22, 20224 yr by Wise87

Performance here have been greatly enhanced with the first patch.

I'm flying VR and it's a GPU bound with all aircrafts.  Only with the FENIX I'm CPU bound, even deporting the VC display to my Integrated GPU. Now with the patch, CPU is still the most solicited, but using VR Motion Reprojection locked to 30fps it's smooth, much better than yesterday.

Hopefully they will continue to enhance performance, just the beginning of the story.

8 hours ago, wiler said:

I have a 5900x +3080 and still can barley squeek out smooth 30FPS.  Your system will probably struggle a bit in both departments. 

Yup more CPU bound than card bound currently...

2 hours ago, roland_lfor said:

Performance here have been greatly enhanced with the first patch.

Same. Just did KSFO to PAKT and flight was perfect, especially performance wise. It looks/seems like the patch made things smoother again, especially at KSFO and 3rd party PAKT. Very happy with the A320 here. Note besides my specs below that I fly VSYNC 30 only